User manual BREVILLE VCF149X

[. . . ] When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury to persons including the following: 1. Adequate precautions must be taken to prevent the risk of burns, scalds, fires or other damage to persons or property caused by touching the exterior whilst in use or during cooling. To protect against electric shock, do not place or immerse cord, plugs, or main body of the appliance in water or other liquids. This appliance can be used by children aged from 8 years and above and by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have Been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. [. . . ] NOTE: coffee will continue to flow for a short time after the Control dial has been moved to the `Standby' position, as coffee drains from the portafilter. Fill the water tank to the "MAX" marking with clean, filtered water. Fill a milk pitcher or cup about to ½ full with cold milk. NOTE: Any type of milk can be used ­ soy, rice, almond, coconut, etc. but full fat dairy milk creates the best froth. NOTE: The ready indicator light will pulse while the water is heating up. Once the unit reaches the correct temperature, the ready indicator light will turn solid. Insert the milk frothing wand tip just below the surface of the milk. Turn the Control dial to steam, and steam will be emitted from the steam wand. Steam your milk until it reaches the desired texture and temperature. nOTE: Steaming milk makes a hissing noise. Take care near hot steam to avoid burns and scalds. When finished, turn the Control dial to the `Standby' position. Then, remove the milk frothing wand from the milk pitcher or cup. NOTE: After steaming milk, the unit must be allowed to cool for a few minutes, or the cool down cycle operation performed as it will be too hot to make coffee. It is recommended when making multiple drinks with steamed milk, you should make the espresso shots first, before steaming the milk. Remember to clean the milk frothing For instructions on how to do so, please referTUtRoN the cleaning section. Tip just below the surface of the And milk pitcher or cup at an Angle that allows thTUeRNmilk to move in a whirlpool pattern. As the milk level rises, lower the Milk pitcher or cup to keep the Milk frothing wand tip just below After steaming, the unit will be too hot to immediately make coffee again. The brew button indicator light will flash rapidly when pressed, and the unit will not dispense if the Control dial is moved to the brew position. The unit can be left to cool naturally for a few minutes, or the following procedure performed. The worktop, ensuring the end of the steam wand is well inside. [. . . ] It may be advantageous to use water as a lubricant to help the rubber cover slide along the length of the shaft. When the drip tray becomes full, carefully slide the drip tray out from the Breville Bijou Espresso machine, remove the drip tray cover, and discard the water. Place the drip tray cover back on the drip tray and slide it into the unit. dESCALING After continued use, your Breville Bijou Espresso machine may develop a build-up of mineral deposits, and therefore require descaling. [. . . ]