User manual BRITAX ADVENTURE

[. . . ] Never use in connection with a 2-point belt!This is how you can use your child safety seat: Forward facing rearward facing with 2-point belt with 3-point belt 2) on front passenger seat on outer rear seat on centre rear seat (with 3point belt) (Please observe the relevant regulations in your country. In a van or minibus) only if the vehicle seat is also approved for use by adults. The seat may not be in the area of effect of an airbag. [. . . ] Engage the buckle tongue in the vehicle seat buckle 10. Inserting the vehicle seat belt into the red belt guides of the child seat. Place the diagonal belt 6 and lap belt 11 on the side of the vehicle seat belt buckle 10 into the red belt guide 12 in the seat cushion 1. The seat belt buckle 10 must not be positioned in the red belt guide 12. Insert the lap belt section 11 on the other side of the seat cushion 1 into the light red belt guide 12 as well. The lap belt section 11 must lie as low as possible over your child's hips. Guide the diagonal belt section 6 into the dark red belt holder 7 of the headrest 3 until it slides behind the safety hook. Please also make sure that the diagonal belt section 6 runs above your child's collarbone and does not rest at his or her throat. You can also adjust the height of the headrest 3 when you are in the vehicle. The diagonal belt section 6 must run slanted towards the back. You can regulate the distribution of the belt using the adjustable seat belt tightener of your vehicle. The diagonal belt section 6 may not guide forwards to the seat belt tightener. In this case, use the child seat on the the rear seat. For the safety of your child, please check that. The belt lap section 11 runs through both sides of the light red belt guides 12 of the seat cushion, · The diagonal belt section 6 also runs through the light red belt guide 12 of the seat cushion on the side of the vehicle seat buckle 10, · The diagonal belt section 6 runs through the dark red belt holder 7 of the headrest, · The diagonal belt section 6 runs slanted towards the back. The straps are tightened and not twisted, · The seat belt buckle 10 must not be positioned in the red belt guide 12 in the seat cushion. The seat cushion 1 is fitted with a foldout cup holder 4 and a small tray 5. In order to prevent injury, never use the trays for. Reach into the finger plate 9 and fold out the cup holder 4 (or the tray 5) out until it locks into place. Small items on the trays can get lost inside the seat cushion. Simply shake these out using the instructions for use holder. In an accident at a collision speed above 10 km/h the child seat could suffer damage which is not necessarily obvious. [. . . ] Buckle: Buckle malfunction is often due to accumulations of dirt and dust which may stop it from working properly. If this happens, the buckle can be washed out. He or she will give you the advice and support you need. when processing claims , product-specific depreciation rates will be applied. [. . . ]