User manual BRITAX AFFINITY

[. . . ] Attaching and removing the seat unit, infant carrier and Britax affinity carrycot with the Click & Go® Adapters 13 13 16 16 17 19 19 20 20 24 25 25 27 5. Attaching and removing the colour pack 20 5. Swivel-lock and front wheel quick release 5. Taking care of your Britax affinity 34 6. [. . . ] Also ensure that when adjusting there is no child in the seat. When folding and unfolding the product, always ensure that the brake is engaged all locks are properly engaged. You can fold your Britax affinity with the seat unit forward facing or without the seat unit. To fold the product press the secondary lock on the right side of the pushchair’s upper tube with your middle finger and pull the release trigger with your index finger upwards towards the handle on both sides. Fold the product to the ground until the chassis lock safely locks around the upper tube and secures the chassis 5. When folding and unfolding the product, always ensure that the brake is engaged all locks are properly engaged. Open the fold lock and pull the pushchair up with each hand holding onto one side of the stroller. Ensure that the chassis is properly installed and that the central hinge has safely locked into place with an audible click noise. When engaging the brake always ensure that you test it by carefully pushing the pushchair with both hands still on the handle bar. There are brake cable adjusters underneath the basket. Please do not change the setting on the cable adjusters. Attaching and removing the seat unit, infant carrier and Britax affinity carrycot with the Click & Go® Adapters WARNING!For attaching the carrycot and infant carriers, please ensure that you follow their user instructions. The Britax affinity uses the innovative Click & Go® attachment system. The Britax affinity seat unit, carrycot and Britax Römer infant carriers use the same adapter system to be attached to the Britax affinity chassis. 14 How to attach/release To attach, just place the Click & Go® adapters over the chassis sockets and push the seat unit into the socket. The adapters will click in with an audible click. Always ensure that your seat unit Click & Go® adapter is fully connected before using the pushchair!To release, use both hands to pull the left and right trigger of the Click & Go® adapter on your seat unit upwards and pull the seat unit away from the chassis. How to attach/release To attach, just place the Click & Go® adapters over the chassis sockets and push the seat unit into the socket. The adapters will click in with an audible click. Always ensure that your carrycot Click & Go® adapter is fully connected before using the pushchair! [. . . ] Adjusting the suspension The rear suspension has two settings hard and soft. To have the full effect of the suspension, always ensure that both sides of the adjustment levers are in the same setting. The infant insert is only suitable for newborns and should only be used with a rearward facing seat unit. When using with the infant insert, do not use and attach the bumper bar! [. . . ]