User manual BRITAX AFFINITY 2

[. . . ] 1 Eignung und allgemeine Bemerkungen 10 Befestigen und Abnehmen der Sitzeinheit, der Babyschale und des BRITAX AFFINITY 2 Kinderwagen-Aufsatzes mit den Click & Go® Adaptern 13 16 16 17 19 19 20 20 24 25 25 26 27 Attaching and removing the seat unit, infant carrier and BRITAX AFFINITY 2 carrycot with the Click & Go® Adapters 13 Adjusting the seat 16 16 17 19 19 20 24 25 25 5. 12 Swivel-lock and front wheel quick release 26 5. Taking care of your BRITAX AFFINITY 2 29 6. Introduction Thank you for choosing the BRITAX AFFINITY 2. [. . . ] For the most compact folding it is best to remove the seat unit entirely and fold the chassis. Fold the product to the ground until the chassis lock safely locks around the upper tube and secures the chassis. When folding and unfolding the product, always ensure that the brake is engaged all locks are properly engaged. Open the fold lock and pull the pushchair up with each hand holding onto one side of the stroller. Ensure that the chassis is properly installed and that the central hinge has safely locked into place with an audible click noise. When engaging the brake always ensure that you test it by carefully pushing the pushchair with both hands still on the handle bar. Please do not change the setting on the cable adjusters. Engaging the brake To engage the brake push the rear end (marked with the red strip) of the brake pedal down. Releasing the brake To release the brake push the front end (marked with the green strip) of the brake pedal down. 5 Attaching and removing the seat unit, infant carrier and BRITAX AFFINITY 2 arrycot c with the Click & Go® Adapters 5. For attaching the carrycot and infant carriers, please ensure that you follow their user instructions. The BRITAX AFFINITY 2 uses the innovative Click & Go® attachment system. The BRITAX AFFINITY 2 seat unit, carrycot and Britax Römer infant carriers use the same adapter system to be at- AVERTISSEMENT !How to attach/release To attach, just place the Click & Go® adapters over the chassis sockets and push the seat unit into the socket. The adapters will click in with an audible click. Always ensure that your seat unit Click & Go® adapter is fully connected before using the pushchair!To release, use both hands to pull the left and right trigger of the Click & Go® adapter on your seat unit upwards and pull the seat unit away from the chassis. How to attach/release To attach, just place the Click & Go® adapters over the chassis sockets and push the seat unit into the socket. The adapters will click in with an audible click. Always ensure that your carrycot Click & Go® adapter is fully connected before using the pushchair!To release, use both hands to pull the left and right trigger of the Click & Go® adapter on your carrycot upwards and pull the carrycot away from the chassis. How to attach/release Please follow the instructions in the user guide of your infant carrier. [. . . ] Close the button between the shoulder pad and the shoulder strap. This needs to be done for left and right shoulder pad. Slide the buckle through the crotch strap. Close the popper on inside of the lower end of the crotch pad and ensure it is connected to the crotch strap. [. . . ]