User manual BRITAX B AGILE

[. . . ] Only use Britax approved child restraints or car seats with this stroller without the use of the Infant Car Seat Adapter Frame. DO NOT allow children to climb on or play with the stroller. Care must be taken when folding or unfolding the stroller to avoid finger entrapment or pinching. Stroller is intended for walking speed only. [. . . ] Do not allow children to climb on or play with the stroller. Care must be taken when folding or unfolding the stroller to avoid finger entrapment or pinching. Stroller is intended for walking speed only. Always set the parking brake when stroller is not moving. Only use accessories and replacement parts approved by Britax Read and understand these instructions before using this product. To ensure proper use, store this user guide in a convenient place so it can be consulted often. Failure to follow all warnings and instructions could result in serious injury or death. When using an infant car seat with this product, refer to the product's user guide for maximum weights and other instructions. Do not exceed the manufacturer's maximum weight limit when using an infant car seat with this product. When using an infant car seat, the front wheel MUST have swivelling turned OFF, and be in the locked position to avoid tipping. Push the release button on the chassis lock and open the frame ?Lift handle until frame locks into upright position front Wheel · Slide the front wheel assembly onto the mounting post at the front of the stroller · Pull wheel to ensure that it is secure Slide the pin on the rear wheel into the mounting bracket on the rear axle until it locks into place · Pull wheel to ensure that it is secure removing Front Wheel · Press the release button on the bottom of the wheel assembly and pull away from the stroller removing Rear Wheels · Pull and hold the release lever on the bottom of the rear axle, while pulling the rear wheel away from the stroller Slide the brackets on the canopy stay into the canopy mounts on the frame of the stroller until they lock into place ?Snap the support strap to the frame just below the stroller handle and connect them using the hook and loop fasteners on the inside of the canopy ?Attach the hook and loop fasteners around the outer edge of the canopy and hood to the stroller Press the brake pedal down to lock the brake · Lift the brake pedal to release the brake NOTE: Locking the brake locks both back wheels swivel Wheels · Press the swivel lock lever down to lock the front wheel · Lift the swivel lock lever to allow the wheel to swivel To recline, pull the release lever on the recline adjuster and slide it away from the seat ?To raise, pull both straps apart Operating Instructions Folding IMPORTANT: Always apply brake and remove children before folding the stroller · Press the frame release button ?Lift the frame release strap in the middle of the seat until the stroller collapses and the chassis lock engages Align the receivers with the Mounts on the inside frame of the stroller Push down until a click is heard Press the button on the receiver and lift upward Release the harness by depressing the button in the center of the buckle while pulling the two top tongues away from the buckle assembly ?Sit child in seat and unzip the seat back to access the harness height adjuster TIP: You may need to loosen the harness to adjust the harness height ?Squeeze the adjuster to release and slide up or down to one of the three locking positions NOTE: Adjusted harness height should be at or above the shoulders of the child Buckle the harness by pressing the tongues on the harness straps into the buckle assembly NOTE: Ensure the straps are not twisted as they may become uncomfortable for the child ?Tighten or loosen the harness straps by sliding the harness adjusters buckle tongues separate for added safety. To reconnect buckle tongues, line up the two pieces and slide the upper portion onto the track on the lower piece Line up the adapter on The infant car seat with the receivers on the stroller NOTE: For non-Britax infant car seats, an adapter frame must be used (sold seperately) ?Lift up on the infant car seat to ensure that it is secure Both sides at the same time NOTE: When removing infant car seat from stroller, take care that the car seat does not tip and fall Front wheel MUST have swivelling turned OFF, and be in Easy attach cup holder fits most cups and bottles Makes the stroller compatible with major manufacturer's infant car seats Extra protection from the cold for your child Protection from the rain for your child Easy storage for drinks and snacks Protects your child from sun and insects while enjoying the outdoors Periodically check that the parking brake works properly and locks both wheels securely. Clean out any dirt or debris that may prevent the brake from working. [. . . ] This warranty does not include damages which arise from negligence, misuse, salt corrosion, or use not in accordance with the user guide. The use of unapproved accessories could cause this product to become damaged or dangerous. Their use automatically voids the Britax warranty. limitations of Damages The warranty and remedies as set forth above are exclusive and in lieu of all others, oral or written, express or implied. [. . . ]