User manual BRITAX BABY SAFE

[. . . ] Baby Safe User Guide Table of Contents Safety Information . 36 This product and its components are subject to change without notice. © 2 0 0 4 B r i t a x C h i l d S a f e t y, I n c . BB0-627-00 / P241000 R1:09/04 · Use only in a rear facing position when using this restraint in the vehicle. [. . . ] A). WARNING: · Always use foot prop when base is installed in vehicle!Foot prop must be in Installation Mode for proper carrier A attachment to base. · Never use foot prop to raise base above vehicle seat surface. Doing so will reduce the stability of the base. Basic Base Functions Using Carrier with Base To attach, line up carrier with base, rear facing, then push down until positive click confirms correct attachment (fig. Check installation by lifting carrier from both ends to verify that both attachment rods are engaged with the base. Visual confirmation can be made, using the button indicator on the rear of the base D (fig. E). WARNING: Carrier must be attached properly to the base. When carrier is attached properly, the green indicator band on the release button is fully visible (fig. E). Adjust foot prop height by pressing Foot Prop Adjust Button while sliding foot prop to the shortest position that provides contact with the vehicle floor (fig. To store foot prop for transport outside of the vehicle, adjust to shortest position, then B collapse into Storage Mode (fig. Press tab into slot on bottom of base to secure. 1 2 To release, press release button on base, then lift carrier to remove (fig. F). IMPORTANT: Always adjust handle to InVehicle position while using in a vehicle. E Indicator C 20 E 21 Base Installation ISOFIX Installation · Figure A illustrates a typical base ISOFIX installation. · Remove carrier before installing base. · Verify that your vehicle is equipped with ISOFIX anchors. If ISOFIX anchors are not available, you must use vehicle belt installation methods. Base Installation 5 Adjust foot prop so that it is against the vehicle floor. WARNING: Never use foot prop to raise base above vehicle seat surface. Doing so will reduce the stability of the base. 6 Attach carrier to base. 1 Place ISOFIX connectors in ISOFIX A Installation Mode. · Remove ISOFIX Protective Cap and spacers, if installed. · Always use foot prop when base is 2 Place foot prop in Installation Mode. installed in vehicle! · Verify that the green indicator band on the release button is fully visible. · Verify that the red line on carrier is level D with the ground. · If angle is not correct, remove carrier and base, then adjust recline angle as directed on page 19. Indicator 3 Line up ISOFIX connectors on base with anchors in vehicle (fig. B). 7 Adjust carrier handle to In-Vehicle position. Removal Squeeze green and red ISOFIX release buttons on each connector (fig. D), then D pull base away from vehicle seat. IMPORTANT: Always store ISOFIX connectors when not in use. [. . . ] · Never remove the buckle tongues from the harness. They cannot be reattached after removal. Care and Maintenance Cleaning the Cover, Belly pad & Head Support Pillow · HAND WASH, using cold water and mild soap. · LINE DRY, to prevent shrinkage. · DO NOT: Bleach, machine wash, machine dry, or iron. Cleaning the Shell & Harness · BRUSH AWAY LOOSE DEBRIS, using a soft bristled brush. [. . . ]