User manual BRITAX BEEPA 4 IN 1 SERIES WA2819A3

[. . . ] The Britax trademark is the property of Britax Excelsior Limited - UK. Visit the Britax website at: http:/www. britax. com. au or email us at custserv@britax. com. au Due to the variations in the style and design of our products the illustrations used in this instruction booklet are generic. 12/06 c 2007 Copyright Britax Childcare Pty. Australia. KEEP INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE 08 4000823 series WA2819A3 CARE AND MAINTENANCE READ THESE INSTRUCTIONS CAREFULLY BEFORE ASSEMBLY AND USE OF THE WALKER. FOLLOW THE MANUFACTURER'S INSTRUCTIONS. [. . . ] · Do not use accessories other than those supplied and approved by Britax. · Discontinue using the baby walker should any part become damaged or broken. · Double check assembly before child is allowed to use the baby walker. · To asvoid burns or injuries ensure, electrical cords, heaters, barbecues, fireplaces and other hot objects are guarded or out of reach. · To prevent injuries, always ensure the child is well clear of any moving parts when adjusting the baby walker. · The baby walker seat should not be used by children who can walk unaided. · Do not use walker until baby can sit up by itself. · To avoid serious injury or death, block stairs and steps securely before using the walker. · Use only on flat surfaces free of objects that could cause the walker to tip over. · Maximum weight or height for child using walker seat is 13kg or 81cm tall. · If used on carpets, the safety grip pads may reduce the walker speed. · Clean safety grip pads regularly to maintain stopping performance (see Care & Maintenance). SAFETY WARNINGS 02 www. britax. com. au www. britax. com. au 07 5. TO ADJUST HEIGHT AND USE BOUNCE FUNCTION PARTS LIST A 1 x Upper plate includes seat B 1 x Walker Car Bonnet C 2 x Support Legs D 1 x Lower base includes foot pedal E 1 x Car windscreen F 4 x Swivel Wheels G&H 2 x Handrails I 1 x Toy Fan J 1 x Toy Horn D NOTE: The support legs can be adjusted to three heights to allow for child's growth. A To adjust seat height turn support leg knobs to `Lock' position. Press the buttons in whilst pushing down on the upper tray. Find the desired height indicated by the numbers 1 to 3 and release the buttons to lock into position. To use bounce function turn the leg knobs to `Jump'. TO ADJUST FOOT PEDAL A A B C B 6. B E F G NOTE: There are 3 foot pedal positions. A B C Push button on foot pedal and slide to adjust to desired position. TO INSTALL AND REMOVE SEAT FABRIC Raise the seat back rest and cover with rear flap of seat cloth. Insert 6 plastic seat slots into corresponding upper plate holes. Turn upper plate upside down, pull plastic seat slots over plastic molding to hold seat in place. Reverse steps A, B and C to remove seat fabric. [. . . ] To remove car bonnet gently pull front wheels away from either side of upper plate molding. Insert the handrails into corresponding holes found on left and right sides of upper plate. A B 3. NOTE: There are two individual battery housings. You will need 5 x AA batteries for lights and sounds. [. . . ]