User manual BRITAX DUO PLUS

[. . . ] We are pleased that our DUO plus may accompany your child safely through a new stage of his or her life. In order to protect your child correctly, the DUO plus must always be used and installed as described in these instructions. If you have any further questions regarding its use, please feel free to contact us. 21 Checklist for correct securing of your child . [. . . ] The tongue and the buckle of the vehicle seat belt are not positioned in the belt guides of the child seat. The diagonal belt is only clamped by the lock-off which is located on the opposite side from the car seat belt buckle. Removal To remove the child seat open the buckle of the vehicle seat belt and take the diagonal belt with a short pull out of the belt lock-off 9. This countermovement releases the interior clamping of the belt lock-off 9 and the clamping lever 8 is now easy to open. Before you install the child seat in the vehicle, please ensure that the shoulder belts are adjusted to the correct height. The shoulder belts 10 must run at shoulder height or a little above the height of the child's shoulders. The shoulder belts 10 must not run behind the back of the child or at ear height or above the ears. The shoulder belts are adjusted as follows: Loosen the harness straps as much as possible (refer to 4. Push with the finger of one hand on the adjuster 15 and with the other hand pull both shoulder belts 10 simultaneously towards you. (Not to the top, not to the bottom, but straight towards you. Open the buckle 17 of the child seat by pressing the red release button . Hook buckle tongues 19 into the rubber holders 29 (are not available on all covers) on the cover on the left and right side. Take the buckle tongues 19 left and right from the rubber holders 29 on the cover. 3) until they lie close to the body of the child. The function of the buckle is very important for the safety of your child. The buckle tongues are only slowly ejected when pressing the red release button. The tongues will no longer lock home (are ejected again). The tongues are difficult to insert (you feel resistance). The buckle only opens after applying extreme force. Put seat shell into "sleeping" position (refer to 5). Grasp the metal plate under the seat shell, with which the crotch belt 20 is secured to the seat shell. Push it upwards, on its side, through the belt slot 22. [. . . ] ) Thread the shoulder belts 10 through the pair of slots 12. Push the shoulder belts 10 at the rear of the seat between the deflection bar 32 and the extension 31 of the shoulder belt height adjuster 14. Hook the shoulder belts 10 at the rear of the seat shell into the yoke 13. Feed the belt loops of the shoulder pads 11 into the pair of slots 12. [. . . ]