User manual BRITAX HI-LINER SG

[. . . ] guarantee All Britax products are carefully designed , manufactured and tested. However, should this product prove faulty within 24 months of purchase due to a materials or manufacturing fault please return it to the original place of purchase. We will then, at our discretion, either repair it free of charge or replace it with the same or a similar product. for guarantee purposes proof of purchase will be required. [. . . ] Once you reach the top slots your child may continue to use the seat until their eye line is above the top of the seat shell. Changing the height of the shoulder straps To loosen the harness, press in and hold the harness release button and with your hand below the chest pads (dia 1a) pull BOTH shoulder straps forwards as far as they will go. Pull the yoke out from behind the seat and unhook one shoulder strap (dia 1c). Pull the cover from the top of the seat so that you can see the slots in the seat shell. Pull the shoulder strap through to the front of the seat. Pass the shoulder strap though the chosen slot and hook the shoulder strap back onto the yoke (dia 1d). Make sure that the straps are not twisted. Rotate the exposed metal strap adjuster (dia 1e) and push it through the slot in the cover and through to the underside of the seat shell. Ensure that it rests horizontally so that it cannot be pulled back through the shell. Pull on the buckle to make sure that it is secure and that the strap adjuster does not come back through. Adjusting the crotch strap IMPORTANT - The buckle should always be positioned low down on your child's body. Snap the buckles of the tether straps onto the tongues on the sides of the child seat 3 . If your car is equipped with a runner loop on the seat runners, these may be used as an alternative (see detail 2f). IMPORTANT - Do not install the tether straps using the Luggage loops. Pull back the child seat cover to reveal the crotch strap. Feed the belt through the lock-off belt guide and seat shell slot (dia 2g), up on to the top face of the seat base, behind the crotch strap (inset) and down through the slot on the other side of the child seat. Open the other lock-off arm, feed the seat belt under the lock-off arm and attach the tongue into the buckle (dia 2h). Pull all of the seat belt slack through the child seat ensuring the seat belt is not twisted (dia 2i). When the belt is as tight as possible, close the lock-off arms on BOTH sides of the seat ensuring that they click into place. If the buckle now lies in the position marked as wrong with a and the seat belt cannot be correctly tightened (dia 2j), try another seating position in the car. Finally tighten the tether straps by pulling the loose ends downwards (dia 2k) until the footprop touches the floor. The footprop must rest on a solid floor - not on lids of storage boxes or similar. [. . . ] Feed the belt through the lock-off belt guide and seat shell slot (dia 3f) on to the top face of the seat base, behind the crotch strap (inset) and down through the slot on the other side of the child seat. Open the other lock-off arm , feed the seat belt under the lock-off arm and attach the tongue into the buckle (dia 3g). Pull all of the seat belt slack through the child seat ensuring the seat belt is not twisted (dia 3h). When the belt is as tight as possible, close the lockoff arms on BOTH sides of the seat ensuring that they click into place. [. . . ]