User manual BRITAX HI-WAY

[. . . ] To refit the cover, use the method shown overleaf (dia 1d). IMPORTANT ­ The cover and chest pads are a safety feature. Don't put your child's safety at risk by using other makes of replacement cover, they could stop the child seat from protecting your child as well as it should. A replacement cover is available from your Britax stockist or contact Britax Customer Service Department on +46 8564 841 00. [. . . ] Pull on the buckle to make sure that it is secure and that the strap adjuster does not come back through. Adjusting the crotch strap IMPORTANT - The buckle should always be positioned low down on your child's body. You must adjust the crotch strap to the correct length for your child BEFORE installing the child seat as it cannot be adjusted in the car. The crotch strap should only be extended when normal harness adjustment is not enough, i. Always return the crotch strap to its original, shorter length when using the seat with a smaller baby. Adjustment is made by feeding the crotch strap through the adjuster (dia 1f). With your other hand pull the shoulder straps forward as far as possible to loosen the harness. The adjuster at the end of the crotch strap is found under the front edge of the child seat. Installing your child seat (rearward facing) in rear side seat IMPORTANT - This child seat has been designed to perform safely and independently of further external restraint. IMPORTANT - The child seat MUST only be used with a lap and diagonal seat belt. The child seat has an adjustable support leg (dia 2a). The smaller the child the more reclined the seat must be. The larger the child the more upright the seat must be. To change the position (if required) pull the support leg clips off of either side and slide the telescopic leg in or out (dia 2b). Once satisfied with the position of the support leg, refit the clips in the holes (inset). Make sure the hole positions chosen are the same on both sides. After installation the gap between the seat in front and child seat should be a minimum of 10mm. If it does then adjust the car seat in front without making the driver or passenger sit in an uncomfortable position. If not try another seating position in the car (dia 2c). Extend the footprop fully and make sure that the footprop tether brackets are facing forwards and that the straps are not twisted. Lower the footprop and adjust the height so that it is within approximately 30mm of the floor (dia 2c). Use the ruler printed on the back page of this manual to get the correct distance from the footprop to the floor. [. . . ] Feed the belt through the lock-off belt guide and seat shell slot (dia 3f) on to the top face of the seat base, behind the crotch strap (inset) and down through the slot on the other side of the child seat. Open the other lock-off arm , feed the seat belt under the lock-off arm and attach the tongue into the buckle (dia 3g). Pull all of the seat belt slack through the child seat ensuring the seat belt is not twisted (dia 3h). When the belt is as tight as possible, close the lockoff arms on BOTH sides of the seat ensuring that they click into place. [. . . ]