User manual BRITAX HUSKY

[. . . ] Husky User Guide Table of Contents Safety Warnings . 10 Installation with Lap-Shoulder Belt (Long Route) . 12 Installation with Lap-Shoulder Belt (Short Route) . 30 This product and its components are subject to change without notice. [. . . ] C). · A positive click confirms attachment. · Verify that LATCH harness is not twisted. C 11 10 Installation Lap-Shoulder Belt Installation Long Route Figure A illustrates a typical long route lapshoulder belt installation. WARNING: · Do not install this restraint using a nonlocking ELR vehicle belt, unless a locking clip is used. Refer to the vehicle owner's manual for instructions on correct use of vehicle belts with child restraints. 1 Insert recline bar into holes on rear of restraint (see page 20). 2 Place the child restraint in a forward facing position on the vehicle seat. 3 Pull the vehicle belt out and pass it through the first belt slot, from the front of the restraint to the rear (Fig B). 4 Route the vehicle belt around the back of the restraint then through the second belt slot, from the rear of the restraint to the front (Fig. C). 5 Verify that the vehicle belt is not twisted, then buckle (Fig. 6 While kneeling on the restraint to push it firmly into the vehicle backrest, remove all slack from the vehicle belt. · First remove slack from the lap portion of the vehicle belt, then the shoulder portion (Fig. E & F). Installation A 7 Verify that the vehicle belt is tight and the child restraint is secure. Refer to Figure G for correct routing of the lap-shoulder vehicle belt. IMPORTANT: Always use the VersaTether for children weighing more than 50 pounds (22. 6 kg). See pages 18-19. D Removal Reverse installation procedure. E B Upper Anchorage Points C 12 G F 13 Installation Lap-Shoulder Belt Installation Short Route Figure A illustrates a typical short route lap-shoulder belt installation. WARNING: · Always use the Versa-Tether® when installing restraint using the short vehicle belt route (see pages 18­19). · Do not install this restraint using a non-locking ELR vehicle belt, unless a locking clip is used. Refer to the vehicle owner's manual for instructions on correct use of vehicle belts with child restraints. E B C 16 17 Versa-Tether® WARNING: ATTACH THE VERSA-TETHER ONLY TO TETHER ANCHORS IDENTIFIED BY YOUR VEHICLE MANUFACTURER AS TETHER ANCHORAGE POINTS. USE OF OTHER LOCATIONS IS NOT APPROVED OR PERMITTED. · ALWAYS USE THE VERSA-TETHER FOR CHILDREN WEIGHING MORE THAN 50 POUNDS (22. 6 KG). · Britax® recommends that the tether be used at all times. [. . . ] 2 Pull retainer away from child restraint to loosen. A 3 Turn the retainer so that the short side will go through the slot in the restraint shell (Fig. 4 Push the retainer through slots in the shell and cover, to the front of the restraint. Care and Maintenance Cleaning the Buckle If your child eats and drinks while in the restraint, you may need to check the buckle periodically and wash out any accumulated debris or dried liquids. B THOROUGHLY RINSE, using warm water (Fig. [. . . ]