User manual BRITAX KID PLUS SICT

[. . . ] We are happy to send you these instructions also in English language. 19 User instructions We are pleased that our KID plus SICT may accompany your child safely through a new stage of his or her life. 21 In order to protect your child correctly, the KID plus SICT must always be used and installed as described in these instructions. If you have any further questions regarding its use, please feel free to contact us. [. . . ] Here is how you can adjust the seat cushion 1 to your child: Grasp the light grey adjustment buttons 16 on the exterior of the side parts 15 by both sides. Press both adjustment buttons 16 upwards and pull the side parts 15 into the widest position. Now press both adjustment buttons 16 again and adjust the side parts 15 to the desired width. Pull up on the side parts to ensure that they are engaged. 3 Adjusting the height of the headrest A properly adjusted headrest 3 ensures the optimum distribution of the diagonal belt section 6 and provides your child with the desired protection and comfort. You can adjust the height of the headrest 3 to eleven positions. € The headrest 3 must be adjusted in such a way that you can still pass two fingers between the your child's shoulders and the headrest 3. To adjust the height of the headrest 3 to fit your child: Grasp the adjustment handle 8 by the back of the headrest 3 and pull it upwards slightly. You can now adjust the released headrest 3 to the desired height. As soon as you have let go of the adjustment handle 8, the headrest will engage. Place the child seat on the vehicle seat. Have your child sit down in the child seat and check the height. Repeat this process until the headrest 3 is at the optimal height. 4 Reclining position of the backrest The backrest 2 of the child seat adapts smoothly to the slant of the vehicle seat. The backrest 2 is held vertically by a small notch. Press the backrest 2 slightly to the rear to release the notch. Please observe: The best possible protection can only be ensured if the vehicle seat is in its upright position. The backrest 2 of the child seat can be inclined backwards into a reclining position independent of the the vehicle seat. To do so, fold out the displacement angle 9 on the back of the backrest 2. Now incline the backrest 2 backwards until the displacement angle 9 lies flat along the back of the vehicle seat. Do not incline the backrest 2 farther than specified by the displacement angle 9. 5 Securing your child The KID plus SICT does not require installation in the vehicle. [. . . ] Unhook the elastic loops 13 of the seat cushion 1. Unhook the buttonholes 19 of the headrest 3. Pull the stopper 17 out of the cover of the wings 15. 3 Re-fitting the cover Simply proceed in the reverse order. [. . . ]