User manual BRITAX MAX-WAY CAR LIST

[. . . ] A snug strap should not allow any slack. It lies in a relatively straight line without sagging. It does not press on the child's flesh or push the child's body into an unnatural position. · Secure the top tether strap provided with this child seat. [. . . ] This child seat must not be used forward-facing for children less than one year of age OR weighing less than 20 pounds. A Forward-Facing E 1 If stored, remove LATCH connectors from storage slots under cover. Pull B both connectors completely through the child seat's right-side, rear-facing belt slot (Fig. B) so they are on the outside of the shell. 2 Press each LATCH adjuster release button and pull each LATCH adjuster strap to full length. 3 Thread the LATCH connectors through forward-facing belt path (Fig. NOTE: It may be necessary to switch LATCH connectors as Release Button shown on page 29 if ANY of the following conditions exist: · LATCH connector is not in an upright position as shown in figure D. · A positive click is NOT heard when LATCH connector and LATCH anchor are connected. F Top 9 Push the child seat into the vehicle seat while pulling each LATCH adjuster strap tight (Fig. 10 Attach the Versa-Tether® hook to an approved tether anchor. Remove all slack from the tether to secure. Store excess webbing in the tether G pouch. 11 Verify all connections are secure and that the child seat is secure. Removal · The child seat is secure when it cannot be moved front-to-back or side-toside more than 1 inch (2. 5 cm. ) at the belt path. D NOTE: If a positive click is not heard, but the LATCH connector is in an upright position, you should not switch the LATCH connector. 7 Verify that the vehicle belt is tight, locked, and child seat is secure. · The child seat is secure when it cannot be moved front-to-back or side-toside more than 1 inch (2. 5 cm. ) at the belt path. Lap-Belt Installation · Figure A illustrates a typical forward-facing, lap-belt installation. · When not in use, always store the LATCH connectors in storage slots. This child seat must not be used forward-facing for children less than one year of age OR weighing less than 20 pounds. IMPORTANT: Britax recommends that the VersaTether® be used at all times. Using the tether will improve the stability of the child seat and reduce the risk of injury. Check your vehicle owner's manual for approved tether anchor locations. A Forward-Facing Removal · If connected, disconnect the Versa-Tether® from the tether anchor. · Press the red release button on the vehicle belt buckle and pull the vehicle buckle from the child seat belt path. B 1 Place the child seat forward-facing on the vehicle seat. 2 If the vehicle is equipped with an approved tether anchor for the chosen seating position, C remove the Versa-Tether® from the pouch and place it up and over the child seat back. 3 Pull the vehicle belt out and thread it through the forwardfacing belt path (Fig. 4 Verify that the vehicle belt is not twisted and buckle (Fig. 5 Push the child seat firmly into vehicle seat while tightening the vehicle belt. · Child seat may be in upright or recline position. See Recline Adjustment on page 30. 22 23 Aircraft Installation Installation: Versa-Tether® Aircraft Installation This child seat is certified for aircraft use. [. . . ] 5 Push the retainer through slots in the shell and cover to the top of the child seat. Cleaning the Harness Buckle If a child eats and drinks while in the child seat, the harness buckle may need to be periodically checked and cleaned of any accumulated food, drink, or other debris or dried liquids. · REMOVE BUCKLE as described on page 36. A · THOROUGHLY RINSE using warm water (Fig. · TEST THE HARNESS BUCKLE by fastening and unfastening until a positive click is heard after inserting each buckle tongue (Fig. [. . . ]