User manual BRITAX MONARCH

[. . . ] Secure booster seat even when unoccupied. In a crash, an unsecured booster seat may injure vehicle occupants. This booster seat is not compatible with vehicle child-restraint anchorage systems (LATCH). Do not use this booster seat with two-point vehicle belts (lap-belt only or shoulder-belt only). [. . . ] x Three-point belts that have separate retractors for the shoulder and lap sections. The vehicle owner's manual will have information on the types of seat belts in the vehicle. If the belt type is listed above, select another seating position. Vehicle Seating Positions WARNING! · Britax and the U. S. Department of Transportation warn that children 12 and under must ride in the rear seats, away from front air bags. The only exception is if the air bag is turned off. When using in a vehicle with air bags, refer to the vehicle owner's manual for additional booster seat installation instructions and precautions. · Only use this booster seat in forward-facing vehicle seats. Side-facing or rear-facing seats in vans, station wagons or trucks CANNOT be used. 7 Features 1 2 3 4 5 6 7 8 1. 8. Headrest Backrest Side wings Armrest (one on each side) Color-coded lap-belt guide (one on each side) Base adjustment lever (one on each side) Retractable cup holder (one on each side) Base 8 Features 9 10 11 12 9. 12. Headrest height-adjustment handle Shoulder-belt guide (one on each side) Recline flap Backrest attachment axle 9 Attaching the Backrest To attach the backrest to the base, place the base on a flat surface and align the back rest evenly with the base. 1 Fold the plastic tab on the backrest upward, align the backrest attachment axle with the axle guide on the base and slide the backrest attachment axle into position. A) A 2 Push the plastic tab under the seat cushion so that it rests on the plastic surface of the base. B) B 3 Swivel the backrest up until you hear a "click. " Backrest is not fully engaged until a click is heard. C) Tip: Always use caution and keep fingers away from moving parts to avoid potential injury. C 10 Adjustments Adjusting the Backrest Use the two-position recline flap to adjust the back angle of the booster seat. 1 Reclined Backrest Position: Pull out the recline flap and slide down until in reclined position. A) A 2 Recline the backrest until the recline flap lies flat along the back of the vehicle seat. B) WARNING: Do not recline the backrest farther than the recline flap will allow. This could cause the backrest to become loose or unstable in the event of a crash. B 3 Upright Backrest Position: Pull recline flap out and slide up until in upright position, flush with backrest. C) WARNING: Whether in reclined or upright position, recline flap should always be in full contact with the vehicle seat when booster is installed. C 11 Adjustments Adjusting the Width of the Base The base width can be adjusted for a proper fit, to improve side-impact protection and provide greater comfort. 1 Before placing child in seat, squeeze both adjustment levers while pulling arm rests apart to achieve the widest base position. A) A 2 Place child in the seat. Squeeze both adjustment levers to adjust the armrests and base width to the desired position. B) Note: Armrests should fit snugly against child's hips. As your child grows, further width adjustments will become necessary. B Adjusting Headrest Height 1 Check fit with child seated in booster seat. With one hand, grasp and pull up on height-adjustment handle located at top rear of headrest. [. . . ] Their use automatically voids the Britax warranty. Limitations of Damages The warranty and remedies as set forth above are exclusive and in lieu of all others, oral or written, express or implied. In no event will Britax or the retailer selling this product be liable for any damages, including incidental or consequential damages, or loss of use arising out of the use (or inability to use) this product. Limitations of Warranties and Other Warranty Terms and State Law Rights Any implied warranties, including implied warranties of merchantability and fitness for a particular purpose, shall be limited to the duration and terms of the express written warranty. [. . . ]