User manual BRITAX MULTI TECH II

[. . . ] 9 months – 6 years) Follow these operating instructions carefully and precisely. If this seat is not securely installed and your child is not strapped in correctly, your child and other passengers are exposed to the risk of serious injury in case of an accident. Please read through these operating instructions carefully, BEFORE installing your child seat. The Hampshire Trading Standards Authority and Britax recommend neither buying nor selling on used child seats. [. . . ] 2e), try it on a different seat in the car. 9-25kg 2f 2g Place the harness around the car seat in front of the child seat, as illustrated (Fig. If your car has an eyelet in the glide rail of the set, this can alternatively be used (Insert in Fig. IMPORTANT – Do not install the fastening belts with luggage straps. 2h Loop the end of the loops of the fastening belts around the seat in front and back again, as illustrated 1 (Fig. Put the ends of the fastening belt toward the outside of the car seat and guide them through the loops 2 . When the support leg brackets are pointing to the front and the belts are not twisted, lock the buckle of the fastening belt into the tongues on the sides of the child seat 3 . Tighten the fastening belts by pulling the loose ends downwards evenly 4 . 1 3 2 4 2i Pull the support leg as far away from the back of the child seat as possible 1 (Fig. Lower the support leg as far as the floor, maintaining the correct angle 2 . Move the support leg and ensure that the support leg is secured. 2 1 2j Finally, ensure that the fastening belts are fully tightened, by pulling down on the loose ends (Fig. The support leg must be resting on solid ground and not on the flaps of storage compartments or similar, at an angle of 100° to the horizontal (Fig. Use the angle measurer on the last page of these operating instructions, in order to check the angle of the support leg against the floor. Check whether the child seat is firmly installed by moving it back and forth, as well as sideways. If it is loose or if the support leg is not at an angle of 100° to the floor, you will need to reinstall it, so that it is secured at the correct angle. 100° 80° Put your child into the seat according to Fig. Installation of your child seat (positioned backward) in a rear middle seat 3a IMPORTANT – The child seat MUST always be used with a lap belt and diagonal belt (approved according to UN/ECE Directive No. IMPORTANT – Do not use any carrying points other than those described in these instructions and those labelled in the child restraint equipment. NEVER install a child seat backwards on a vehicle seat that is equipped with an airbag. Pull the lap and diagonal harness out sufficiently (approx. 2 1 3j Finally, ensure that the fastening belts are fully tightened, by pulling down on the loose ends (Fig. [. . . ] Turn the bracket so that is fits through the graduated belt and push it onto the front of the seat (Fig. Place the child seat upright and remove the belt from the buckle (Insert in Fig. Push the belt brackets and buckle tongues under the cover through the lap belt holes (Fig. Put the buckle, belt straps and chest pads into the elastic holding straps (Fig. [. . . ]