User manual BRITAX PREVIEW

[. . . ] · Always make certain that the stroller is fully open and locked before use. · Assembly of this stroller must be performed only by an adult. · Do not hang or place items on the stroller handle or frame. They may cause the stroller to become unsafe. [. . . ] G). H To prevent front wheels from swiveling, turn wheels forward, then lift swivel lever up until engaged with notch (fig. H). 6 7 Operating Instructions Backrest Hood (cont. ) Operating Instructions A To lower backrest, press release button on each backrest recline adjuster, while lowering backrest to one of four available positions (fig. A). B To raise backrest, push backrest up until in one of four available positions (fig. B). E F To Open Hood, pull hood forward (fig. E), then engage each hood lock by pressing down (fig. F). Hood C To Attach Hood, press two attachment clips onto each side of stroller frame (fig. Attach hook and loop fastener strips (3x) at rear of hood (fig. D). 8 D To Remove Hood, lift tab on each attachment clip (4x) to release from stroller frame. Release hook and loop fastener strips at rear of hood. G H To Collapse Hood, release each hood lock by pressing up at center (fig. G), then hood backward to collapse (fig. H). 9 Operating Instructions Arm Bar Attachment Clip Operating Instructions Carrier Attachment (cont. ) A To Remove Arm Bar, release and remove each attachment clip, located under armrests (fig. IMPORTANT: If removing for use without arm bar, replace attachment clips. B To Install Arm Bar, release and remove each attachment clip, located under stroller armrests. Slide arm bar into slots on stroller armrest, then replace attachment clips (fig. B). E 4 Press carrier onto arm bar until clicks are heard, which confirms attachment (fig. E). F 5 Check installation by lifting carrier from rear to verify that both attachment hooks are engaged with the arm bar (fig F). Carrier Attachment Carrier Removal Arm Bar Attachment Hooks C 1 If arm bar is installed, remove zippered cover. If arm bar is not installed, Install arm bar with smooth side up (fig. C). D 3 Lower backrest into full recline position (pg. 4 Place carrier rear facing in stroller, with attachment hooks aligned with arm bar (fig. D). G 6 Raise stroller backrest to fully secure carrier. To raise backrest, push backrest up until in one of four available positions (fig. G). H 1 Fully recline stroller backrest (pg. 2 Squeeze release lever on restraint, while lifting restraint from stroller (fig. [. . . ] It is not designed to be compatible with other child restraints or carriers. The use of unapproved accessories could cause this product to become damaged or dangerous. Their use automatically voids the Britax warranty. Limitations of Damages The warranty and remedies as set forth above are exclusive and in lieu of all others, oral or written, express or implied. [. . . ]