User manual BRITAX ROADSTER 2 IN 1 WALKER

[. . . ] TOY TRAY FUNCTION E Right side dial is on/off and volume. When rotated clockwise from the off position, the Toy Tray will be on. The white dot indicates the maximum volume point. CARE AND MAINTENANCE Left Right Make sure the dial clicks into the off position when not in use. F Left side dial changes music function from music tunes to "piano" mode. [. . . ] NOTE: All music buttons when pushed will stop other functions and return to music mode. A Locate the battery section lid on the underside of the Toy Tray. You may need a screwdriver or tool to open the cover. Insert 3 x AA batteries following the orientation indicated. Replace the lid, replace the screw, tighten screw to lock the battery lid. Insert the Toy Tray into the seat tray cavity. Push forward and down to engage into the seat frame. To remove Toy Tray, pull up from the finger recess. 1. ASSEMBLY - WHEELS NOTE: For easier assembly, turn the lower base frame upside down. Turn right side up after wheels have been assembled. A B Insert the wheel posts fully into the holes located at each corner of the base using moderate force. Insert all 4 wheels. B C D NOTE: Clean grip pads regularly, using warm water with a household soap or mild detergent to maintain stopping performance. 5. WALKER FUNCTION WALKER MODE(FIXED SEAT POSITION): NOTE: To lock the support legs from Bounce into Walker mode, select one of the 3 height positions. A If in number 1 position Bounce mode, push in and turn the RED button towards the LOCK position. To lower the seat to number 2 or 3 position, push in and turn the RED button from Lock towards Jump mode. Now push down on the seat frame until you see the number 2 or 3 appear. Push in the RED button and turn towards the LOCK position. The seat frame should now be locked into this position. NOTE: You might need to adjust the leg tube up or down a little to allow the LOCK pin to engage the support leg. D To release back to Bounce mode, push in and turn the RED button (on both sides) towards Jump indicator. [. . . ] INSTALLING AND ATTACHING THE SOFT SEAT TO THE SEAT FRAME NOTE: The soft seat must be secured to the frame by the webbing straps. A B C D Firstly, raise the plastic backrest support up and lock it into position. Position the soft seat onto the seat frame by lowering the soft seat pocket over the plastic moulding. One by one, thread each of the webbing straps through the locating holes in the seat frame. From the underside, pull the webbing straps all the way through until the plastic moulding locks through the hole. [. . . ]