User manual BRITAX STARRISER COMFY

[. . . ] · Secure this child restraint even when it is not occupied. In a crash, an unsecured child restraint may injure vehicle occupants. · This booster seat is not compatible with vehicle child restraint anchorage systems (LATCH). · Do not use this booster with two-point vehicle belts (lap belt only or shoulder belt only). [. . . ] You must register this restraint to be reached in a recall. Send your name, address, and the restraint's model number and manufacturing date to Britax Child Safety, Inc. 13501 South Ridge Drive Charlotte, NC 28273 or call 1-888-4BRITAX. Government's Auto Safety Hotline at 1-888-327-4236. 4 5 Vehicle Safety Belts IMPORTANT: Some vehicles have no seating positions that are compatible with this booster seat. If in doubt, contact the vehicle manufacturer for assistance. To protect your child in a crash, you must use this booster seat with compatible vehicle safety belts. Only use with three-point (lap and shoulder) safety belts that are not motorized or anchored on the vehicle door. The following types of vehicle belts are not compatible with this booster seat: Two-point belts of any kind. Front vehicle belts with top or bottom anchorage points in the door. Three-point belts that have separate retractors for the shoulder section and the lap section. The vehicle owner's manual will have information on the types of seat belts in the vehicle. If the belt type is listed above, select another seating position. This booster seat can fit securely in most vehicles using the existing vehicle belts. However, some types of vehicle designs prevent a secure fit, due to the position of vehicle belt lower anchorage points. 6 Vehicle Seating Positions WARNING: · Britax and the U. S. Department of Transportation warn that children 12 and under must ride in the rear seats, away from front air bags. The only exception is if the air bag is turned off. When using in vehicle with air bags, refer to the vehicle owner's manual for additional child restraint installation instructions and precautions. · Forward facing vehicle seats MUST be used with this booster seat. Side facing or rear facing seats in vans, station wagons or trucks CANNOT be used. 7 Starriser ComfyTM: Adjustments IMPORTANT: This section applies only to the Starriser Comfy. If you are using a Starriser, refer to page 12. The purpose of the Starriser Comfy belt-adjusting booster with backrest is to adapt the adult vehicle safety belt to the body size of the child. It is important to adjust the width of the booster base correctly and to use the belt guide to properly align the safety belt. Adjusting the Base The armrests of the Starriser Comfy must be snug against the hips of the child to properly align the lap belt across the child's hips. Starriser ComfyTM : Adjustments Removing the Backrest 1 Pull connector release button (Fig. [. . . ] The use of non-Britax Child Safety, Inc. covers, inserts, toys, accessories, or tightening devices is not approved by Britax. Their use could cause this restraint to fail Federal safety standards or perform worse in a crash. Their use voids the Britax warranty. Cleaning the Shell SPONGE CLEAN, using warm water and mild soap. [. . . ]