User manual BRITAX WEEKENDER 3 IN 1

[. . . ] The Britax trademark is the property of Britax Excelsior Limited - UK. Visit the Britax website at: http:/www. britax. com. au or email us at custserv@britax. com. au Due to the variations in the style and design of our products the illustrations used in this instruction booklet are generic. 12/06 c 2007 Copyright Britax Childcare Pty. Australia. KEEP INSTRUCTIONS IN SAFE PLACE FOR FUTURE REFERENCE 12 4001054 series R032S CARE AND MAINTENANCE BEFORE ASSEMBLING THIS COT READ AND UNDERSTAND THE INSTRUCTIONS. INCORRECT ASSEMBLY MAY MAKE THE COT UNSAFE. [. . . ] The thickness of the mattress has been specified to ensure that the distance from the top of the mattress to the top of the lowest side or end will always be at least 500mm. This will reduce the risk of children falling out of the cot. Always check parts regularly for tightness of screws, nuts and other fasteners - tighten if required. Use only the mattress supplied with the cot. Do not use an additional mattress, padding, toys or other objects in the cot which would help your child fall out. Using the wrong size mattress may create hazardous gaps that could result in suffocation or could reduce the side height of the cot, which may result in your child falling out of the cot. THIS PRODUCT IS NOT INTENDED FOR COMMERCIAL USE. 02 www. britax. com. au www. britax. com. au 11 NOTES WARNING - MATTRESS SIZE This cot is made for a mattress which is 740mm wide, 1000mm long and no more than 25mm thick. Using the wrong size mattress may create hazardous gaps that could result in suffocation or could reduce the side height of the cot which may result in your child falling out from the cot. For its correct use, ensure you follow these instructions in the order that they are written. PARTS LIST A B C D E F 1 - Carry bag 1 - Mattress 4 - Mattress Support Rods 1 - Cot 1 - Bassinette 1 - Change Table A B C D E F 10 www. britax. com. au www. britax. com. au 03 1. TO OPEN THE COT THESE STEPS WILL ENSURE THAT THE COT IS CORRECTLY OPENED AND READY FOR USE. A B C D E Unzip the carry bag and remove the cot. Stand the cot on its feet and undo the hook & loop straps that hold the mattress around the frame. Remove the mattress and set other accessories aside. Starting with the short rails pull the centre up with both hands quickly until they are locked in place. 5. TO USE THE CHANGETABLE (con't) C D Pick the changetable up by the plastic hooks and connect to the Portable Cot short end rail as shown. Rotate the Changetable over the Portable Cot and engage each of the four clamps onto the side rails. Move the Bassinette clamps slightly if they interfere with attaching the Changetable. A C NOTE: MAKE SURE THE FOUR CLAMPS ARE ENGAGED ON TO THE SIDE RAILS. E B C F Pull the pocket flap over the end of the Portable Cot. Attach the plastic clamps to the leg tubes to keep the pocket in place. When the Changetable is not in use, always fold over the end rail until required again. C (CAUTION: TAKE CARE, AS FINGER PINCHING CAN OCCUR IN THE CORNERS WHEN LOCKING THE RAILS IN PLACE. ) F Now do the same with the longer rails. G To remove the Changetable, release the plastic hooks from the top rails. D D NOTE: ALL THE TOP RAILS SHOULD BE LOCKED IN PLACE. IF THEY ARE NOT, RELEASE THEM AND TRY AGAIN. THE CENTRE OF THE COT BASE MUST BE IN A RAISED POSITION TO ALLOW THE RAILS TO LOCK EASILY. [. . . ] TO USE THE BASSINET A Insert the 2, two-piece support rods into bassinet inner sleeves separately, then engage them in the middle by the locking pin. Insert the mattress and secure it to the bassinet by passing the loop straps through the slots in the bassinet base, then press the loop straps onto the hook padding, sewn to the underside of the bassinet. Lower the bassinet within the cot with warning label at short end. A B B IF THE TOP RAILS DO NOT FOLD - DO NOT FORCE THEM - LIFT THE BASE HIGHER AND RE SQUEEZE THE BUTTONS TO FULLY RELEASE THEM. [. . . ]