User manual BROTHER 3034D BROCHURE

[. . . ] When using the sewing machine, basic safety precautions should always be followed, including the following. The sewing machine should never be left unattended when plugged in. Always unplug this sewing machine from the electrical outlet immediately after using and before cleaning. Always unplug before replacing the light bulb. [. . . ] Pull the thread off the spool and directly up through the thread holder 1 and the thread plate 2 on the thread tree from back to front. Pass the thread through the tension disc 4 which is in the channel next to the pink tension adjustment dial. Guide the thread down the channel and across through the threading points 5 6 7 next to the pink color marks following the numerical order in the accompanying illustration. NOTE: Make sure the thread is through the right of the separater <A>. Pull the thread off the spool and directly up through the thread holder 1 and the thread plate 2 on the thread tree from back to front. Pass the thread through the tension disc 4 which is in the channel next to the yellow tension adjustment dial. Guide the thread down the channel and across through the threading points 5 6 7 next to the yellow color marks following the numerical order in the accompanying illustration. NOTE: Make sure the thread is through the left of the separater <A>. Bring the thread down through the needle bar thread guide and through the right needle 8 from front to back. Bring the thread down through the needle bar thread guide and through the left needle 8 from front to back. This sewing machine can sew five different stitches by following the simple steps below: Use all four threads and two needles for producing four-thread overlock stitches. NOTE: You can use the optional accessory foot for even more varieties of stitches. Use three threads and the left needle, producing 5 mm (3/16 inch) seams. NOTE: Remove the right needle when sewing this overlock stitch. Thread the machine and pull all threads out about 15 cm (6 inches) behind the presser foot. NOTE: Remove the left needle when sewing this overlock stitch. Place a piece of scrap material under the presser foot for test sewing. nOTE: Always lift the presser foot before placing the fabric under it. You cannot start sewing by just running the fabric under the foot without lifting the presser foot. Holding all threads with your left hand, turn the hand wheel slowly a few times toward you, and check to see that the threads entwine themselves before using the foot controller to sew. Lift the presser foot and place the material well underneath the presser foot before starting to sew. Slowly sew a few stitches by turning the hand wheel. [. . . ] Set up the machine for 3 thread overlock stitch with one needle in the left position. Sew turning hand wheel by hand until the pearl comes through the tunnel. Sew at slow speed while guiding the pearl and fabric by hand. NOTE: Thread tension is easy to loosen especially for small size pearl. [. . . ]