User manual BROTHER M-4318

[. . . ] Failure to fit the ink cartridges into the Printer during shipping will cause severe damage to the Printer and will VOID THE WARRANTY. 1 DO NOT remove the ink cartridges. (On/Off) button to turn Push the the printer off. 2 Turn your computer off and remove the Printer Interface Card from the computer. Remove the PC Card cable from the printer and from the Printer Interface Card. [. . . ] · When you carry the printer, move the printer and Feeder carefully as shown below. Do not hold only the Feeder when carrying the printer. Be sure to set the Printer Stand in the original position before removing the Feeder. ! Caution Fig. 2-13 The Printer and the Auto Cut Sheet Feeder Note If the paper will not load from the Feeder, use the Paper Feeding Slot and try again. Ensure that the latches are connected securely and tilt the Feeder fully. 2-11 USER'S GUIDE How to Remove the Auto Cut Sheet Feeder from the Printer 1. Open the Feeder Cover and remove the paper. Fold the wire back in the Auto Cut Sheet Feeder, and close the Feeder Cover and then tilt the Feeder forwards. ! Caution Ensure you move the Paper Guide to the left, otherwise it will cause damage to the Auto Cut Sheet Feeder. Open the Latches(x) on the rear of the Cut Sheet Feeder by them forwards and push the Latches(y) on both sides inwards into the sheet feeder. Remove the Auto Cut Sheet Feeder from the Printer. Fig. Set the Latches on both sides of the Cut Sheet Feeder to the normal position. Fig. 2-15 Latches ! Caution Treat the Latches carefully so that they do not break. 2-12 CHAPTER 3 CONTROL PANEL CHAPTER 3 CONTROL PANEL LED AND BUTTONS This section refers to the following LEDs and buttons on the printer control panel. Fig. Wait until all the LEDs stop blinking. ! Caution Do not remove cables when the printer is cleaning its print head. Note You can also clean the print head from the printer driver. Select `Maintenance' from the `M-4318 series' group in Windows. Automatic Periodical Cleaning This printer carries out Automatic Periodical Cleaning to ensure that the printer maintains optimum print quality at all times. This setting will use ink during the cleaning sequences. If you want to only clean the print head by manually selecting cleaning, you can turn this setting off through the printer driver. This setting will save ink but you will need to clean the print head manually when necessary. To turn the setting to off, select 'Maintenance' from the M-4318 series group in Windows. Note When you carry out cleaning 3 times within one hour by using the printer clean button, the third clean will become a 'Power Clean'. 4-1 USER'S GUIDE REPLACING THE INK CARTRIDGES (BC) LED and/or (MY) LED) blink or When the Ink LED(s) ( come on, replace the indicated color ink cartridge with a new one. We strongly recommend you only use Brother original ink cartridges for the printer as these will provide the best print quality. Using other ink may void the warranty for this printer. Black & Cyan Magenta & Yellow LC03BC LC03MY · Make sure that the (On/Off) LED is on when you replace the ink cartridges. (BC) LED and/or · When the ink has run out, the Ink LED(s) ( (MY) LED) turn on. [. . . ] Some colors are missing. Printed paper is damaged by excessive ink. The space between lines of text is narrower than you have set. Banding appears. Recommendation You may have printed in Draft mode. Set to Normal mode or Super Fine mode in the printer driver. [. . . ]