User manual BT CONVERSE 325

[. . . ] There is a serious risk of explosion and/or the release of highly toxic chemicals. Environmental Do not expose to direct sunlight. We recommend that you do not place the product on antique/veneered wood to avoid damage. Do not stand your product on carpets or other surfaces which generate fibres, or place it in locations preventing free flow of air over its surfaces. [. . . ] Press the VOL + or VOL button to increase or decrease the volume. HI LOW OFF One-Touch and Two-Touch memories You can store 20 telephone numbers in your Converse 325. 10 in the One-Touch memory and a further 10 in the Two-Touch memory. Please note that stored numbers can be no longer than 21 digits. Note The call indicator light will flash regardless of the ringer setting chosen. To adjust the ringer tone The ringer tone can be set to High or Low. Use the ringer tone switch on the underside of your Converse 325 to set the ringer tone you want: R1 for LOW or R2 for HIGH. USING To store a One-Touch number Use the label to keep a note of each One-Touch and Two-Touch numbers. Note R1 R2 RINGER To adjust the call volume During a call, you can adjust the volume of a call. When using Handsfree: Press the VOL + or VOL button to increase or decrease the volume. One-Touch memory buttons 6-10 (the bottom 5 buttons) are pre-set with BT Calling Features numbers (see `Using Calling Features'). These can be overwritten if you wish by following the instructions below. Press the Store button. 10 Press the Memory button under which you want to store the number. Enter the telephone number you want to store. Note To change a stored number, repeat the steps shown above. The new number will replace the existing One-Touch or Calling Features number. To dial a Two-Touch number Press the Handsfree button. The number is dialled. To store a number longer than 21 digits Store the first 21 digits as shown previously, then repeat the steps to store the remaining digits under another Memory button. USING To dial a One-Touch number Press the Handsfree button and press the Memory button you want. The number is dialled. To dial a stored number of more than 21 digits Press the Handsfree button. Press the Memory button which contains the first 21 digits. Press the Memory button which contains the remaining digits. The number is dialled automatically. To store a Two-Touch number Press the Store button. Press the Memory button under which you want to store the number. Enter the telephone number you want to store. The number is stored. 11 To store a pause in a memory number A pause is sometimes required with switchboards and Network Services. A pause simply gives the switchboard a few seconds to pick up the outside line before dialling. Using the Redial button, you can insert a pause in numbers stored in the memory. The 1471 ­ Call Return information is announced. 1571 ­ Call Minder/BT Answer 1571 (Quarterly subscription/No Charge) Reminder Call on (Pay per call) Reminder Call off 55 #55# You can replace the pre-set numbers with your own numbers, if you wish. [. . . ] Rotate the handset clip 180° so that it protrudes upward. This holds the handset in place when wall-mounted. DATA LINE 7 2 Unclip the line plug from the telephone base. Unclip the stand from the base of the telephone and remove the stand. 8 3 Hang the holes on the back of the phone over the screwheads and gently pull the phone downward to make sure it is securely in place. Hang the handset on the handset clip. 9 4 Reconnect the telephone line to the line socket on the base of the phone. If you need to leave the phone whilst on a call you can hang the handset on the park at the top right hand corner of the product. 20 60mm Wall 60mm Index At a glance Batteries install low warning 1 5 5 5 12 15 15 14 7 14 14 15 15 16 16 17 7 9 7 7 8 9 13 5 18 18 9 8 7 Making calls Memories dial one-touch number dial two-touch number store a pause store one-touch number store two-touch number Memory back-up Message waiting indicator Phone socket Preparatory dialling Recall button Receiving calls Redial last number repeat dial Reminder call Ringer tone Ringer volume Safety information Secrecy Setting up Switchboard compatibility Calculator Call Diversion Call Minder/BT Answer Call Return Call timer Calling Features 1471 ­ Call Return 1571 ­ Call Minder/BT Answer Call Diversion Other Services Reminder Call reset buttons Calls end handsfree make receive redial secrecy Data port Dialling mode General information Guarantee 7 10 11 11 12 10 11 12 9 5 7 12 7 8 8 8 16 10 10 4 9 5 19 19 6 10 10 20 INDEX Technical information Time ­ set Volume caller's speech ringer Handsfree Headset Hearing aid compatibility Wall-mounting 21 Visit us at www. bt. com Offices worldwide The telecommunications services described in this publication are subject to availability and may be modified from time to time. [. . . ]