User manual BUFFALO HD-HBU2 : DRIVESTATION

[. . . ] The front face of the DriveStation has a protective plastic film covering for protection from scratching during assembly and shipping. The film can be removed by peeling it away from any corner of the front face. www. buffalotech. com QSG-HB160/250-U2 DriveStation Setup Flip the power switch on the back of DriveStation to the OFF position. Plug DriveStation's power cord into a power outlet. Then, connect the included USB cable into the USB port on the back of DriveStation. Connect the USB cable into the USB port on the computer or device you are adding the DriveStation to. 2 DriveStation Setup Windows 2000 & XP Flip the power switch on the back of the DriveStation to the ON position. In Windows 2000 and XP, the DriveStation will automatically install upon power-on. Open `My Computer' and the new drive will be present. [. . . ] Consult the manual for the Disk Formatter Utility for more help. The manual can also be found on the DriveNavigator CD-ROM. I cannot see the DriveStation in `My Computer'. Verify that the POWER light is lit green. If it is not, then ensure that the power switch is in the ON position. Try toggling the POWER MODE switch right below the power switch. The POWER MODE switch toggles whether the device is powered up via a USB signal or purely based on the power switch's position. If you have installed the Power Save Utility, then verify that the DriveStation was not put into power saving mode. Consult the manual for the Power Save Utility for additional help. The manual can be found on the DriveNavigator CD-ROM. Verify that the hard drive inside the DriveStation is spinning. This can be verified by placing your hand on the sides of the case and feeling for a slight vibration. Also, after the DriveStation has been powered on for fifteen minutes or more it will begin to get warm. If neither of the preceeding tests verified that the hard drive is spinning, then please call technical support at 866-752-6210 for further assistance. If you are experiencing any additional troubles, please contact our live 24x7 technical support for additional assistance. They can be reached toll-free at (866) 752-6210. 6 Technical Specifications USB Standards: Capacity: Seek Time: Transmission Speed: Power Consumption: Power Supply: Dimensions: Weight: Operating Environment: USB Specification Rev. 25W, Average 17W AC100V 50/60Hz 53(W) x 173(H) x 164(D) mm 3. 15 lb. 5 - 35 degree C 20-80% humidity (non-condensing) Technical Support Buffalo Technology offers toll-free technical support 24 hours a day, 7 days a week for this product. Customers in the United States and Canada may obtain technical support using the following information: Web: E-mail: Telephone: www. buffalotech. com info@buffalotech. com 866-752-6210 (USA & Canada only) FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 7 Warranty Statement Buffalo Technology (USA) products come with a one-year limited warranty from the date of purchase. Buffalo Technology (USA) warrants to the original purchaser the product; good operating condition for the warranty period. [. . . ] All RMAs are governed by the RMA policy or procedures of each individual reseller selling Buffalo WLAN products. In no event shall Buffalo Technology (USA) liability exceed the price paid for the product from direct, indirect, special, incidental, or consequential damages resulting from the use of the product, its accompanying software, or its documentation. Buffalo Technology (USA) does not offer refunds for any product. Buffalo Technical Support Information (Please have your proof of purchase when calling Buffalo Technical Support) United States of America & Canada Buffalo Technology (USA) Inc. [. . . ]