User manual BUFFALO HD-QLU3 DRIVESTATION QUAD USB 3.0

[. . . ] Power On: blue RAID Maintenance: purple These indicate the status for each internal hard drive of the DriveStation. the number next to the LED corresponds to the hard drive number. Power On: green Accessing: blinking green Rebuilding: blinking red Error: red (see Troubleshooting) Connect to your computer with the included USB cable. Install in an environment where the fan is not blocked. [. . . ] FAT 32 format doesn't support files larger than 4 GB. Windows XP doesn't support drives larger than 2 TB. When formatting the DriveStation with a capacity larger than 2 TB, select "NTFS Compatible" or "FAT32-Compatible". This divides the drive area into partitions not exceeding 2 TB for formatting. When formatting a capacity larger than 2 TB in Windows Vista, selecting "NTFS (GPT)(Recommended)" enables the creation of drive areas larger than 2 TB. However, in this case, the drive area cannot be used in Windows XP. When the message "If the disk configuration is changed, all data on the drive will be erased. When "Check again that there is no important data on the target drive. " is displayed, disconnect the DriveStation from the computer, then reconnect it. Building of the RAID array is now complete. Notes: For users of Windows Server 2003 After building the RAID array, the DriveStation must be initialized using the NTFS format. format the DriveStation while referring to the on-screen manual "Formatting Guide". For Macintosh users After building the RAID array, the DriveStation must be initialized using the MacOS Extended format. initialize the DriveStation while referring to the on-screen manual "Formatting Guide". If the DriveStation is connected to a computer after building the RAID array, the access lamp may glow green and the DriveStation may not be recognized properly. In this case, turn off the power for the DriveStation, then turn it on again. Log" file is automatically created in the folder where the RAID Utility was installed (default installation directory is C:\Program Files\BUFFALO\HD-xLU3). the information below is contained in the log file. System log records [2010/xx/xx xx:xx:xx][Information label][Log record content] Log recording date INFO=Information WARN=Warning ERR=Error Device log records [2010/xx/xx xx:xx:xx][Information label][P/N=xxxxxxxxxx][Log record content] Log recording date INFO=Information WARN=Warning ERR=Error In the RAID Utility, the RAID Maintenance function can be set for periodically checking for errors due to bad sectors and automatically rebuilding when an error is found. the RAID Maintenance function is set as shown below. Note: The screens may vary depending on the OS you are using. You may continue to use the DriveStation during RAID maintenance, but this increases the time required for RAID maintenance to complete. [. . . ] If you use this drive with a low-speed USB 2. Sobald "Check again that there is no important data on the target drive. Um POP before SMTP zu verwenden, wählen Sie "Use [POP before SMTP] ([POP before SMTP] verwenden)" und geben dann Adresse, Portnummer, Benutzerkonto und Passwort des POPServers ein. Wenn unter Windows die Meldung , , Do you want to allow the following program to make changes to this computer? [. . . ]