User manual BUFFALO WBR2-G54

[. . . ] User Manual 125 High Speed Mode* Wireless Cable/DSL Router WBR2-G54S www. buffalotech. com/wireless Table of Contents Introduction . 43 2 Table of Contents Network Settings. 69 3 Table of Contents Specifications . 94 4 Introduction AirStation 125 High Speed Mode Wireless Cable/DSL Router (WBR2-G54S) This manual introduces you to the AirStation Cable/DSL Router, and will help you connect to your network quickly. [. . . ] · Prohibit NBT and Microsoft-DS routing - Prevent unexpected external access via Microsoft network sharing. This prohibits computers on the internet from accessing shared resources on Windows machines. It is recommended to leave this filter activated. · Reject the IDENT request - The AirStation sends reject packets if it receives an IDENT request. 50 Advanced Settings Basic Filter Setting Use this filter when the communication speed goes down using a network application like E-mail, FTP and WEB. * If IDENT requests are forwarded to a LAN side client by address translation setting (DMZ or TCP port :113 ), this basic rule is ignored. 51 Advanced Settings IP Filter Settings - Limits the type of packets allowed to pass between the WAN and LAN. · Operation - Packets from WAN (or LAN), select ignored, rejected, or accepted. Select the operation to be performed on the packets. Packets from: IP Filter setting · WAN side - packets coming from the WAN side will be filtered. · LAN side - packets from the LAN side will be filtered. Are : · Ignored - Stop the packet and do not route it. · Rejected - Return the rejected packet to the point of origin. · Accepted - Pass the packet through. · Destination IP Address - The IP address to be filtered. · Source IP Address - The IP address designated for filtering. If all IP addresses must be filtered, leave this box blank. Warning: If administrator selects packet from LAN is Ignored or Rejected, the administrator will 52 Advanced Settings no longer have access to the AirStation configuration screens. This function prohibits setup from a wireless or wired computer. The AirStation can be returned to the factory default settings by holding down the INIT button on the back of the unit for five seconds or until the red DIAG light becomes solid. Protocol - Mark and select a specific protocol. Select from all protocols, ICMP, arbitrary protocol number and TCP/UDP protocol number. · All - Selects all IP protocols. · ICMP - Network Diagnostic Protocol (1). [. . . ] -Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. 91 FCC / CE Information FCC RF Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. [. . . ]