User manual BUFFALO WHR3-G54

[. . . ] User Manual 125 High Speed Mode* Wireless Cable/DSL Router WHR3-G54 Rev B www. buffalotech. com/wireless Table of Contents Introduction . 43 2 Table of Contents Network Settings. 69 3 Table of Contents Specifications . 94 4 Introduction AirStation 125 High Speed Mode Wireless Cable/DSL Router (WHR3-G54) This manual introduces you to the AirStation Cable/DSL Router, and will help you connect to your network quickly. [. . . ] · Operation - Packets from WAN (or LAN), select ignored, rejected, or accepted. Select the operation to be performed on the packets. Packets from: IP Filter setting · WAN side - packets coming from the WAN side will be filtered. · LAN side - packets from the LAN side will be filtered. Are : · Ignored - Stop the packet and do not route it. · Rejected - Return the rejected packet to the point of origin. · Accepted - Pass the packet through. · Destination IP Address - The IP address to be filtered. · Source IP Address - The IP address designated for filtering. If all IP addresses must be filtered, leave this box blank. Warning: If administrator selects packet from LAN is Ignored or Rejected, the administrator will 52 Advanced Settings no longer have access to the AirStation configuration screens. This function prohibits setup from a wireless or wired computer. The AirStation can be returned to the factory default settings by holding down the INIT button on the back of the unit for five seconds or until the red DIAG light becomes solid. Protocol - Mark and select a specific protocol. Select from all protocols, ICMP, arbitrary protocol number and TCP/UDP protocol number. · All - Selects all IP protocols. · ICMP - Network Diagnostic Protocol (1). · Manual - Enter protocol number (0-65535). · TCP/UDP Destination Port - Select TCP or UDP, then enter port number. Priority - Specify the priority an item. The smaller the number, the higher the priority. Add MAC Filter setting MAC Filter - Click Enter MAC filter to enter MAC address. Source MAC address -The MAC address of the source of the packets that will be filtered may be set. [. . . ] -Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. 91 FCC / CE Information FCC RF Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. [. . . ]