User manual BUFFALO WLI-TX1-G54 QUICK SETUP

[. . . ] Ethernet Cable AC Adapter Quick Setup Guide Warranty Statement If any items are missing, please contact the reseller from whom you purchased this product. System Requirements Desktop or Notebook Computer with an available Ethernet (RJ-45) port Web browser 5. 0 or later 802. 11b or 802. 11g access point (Infrastructure Mode) OR a different computer with an 802. 11b or 802. 11g wireless adapter (Ad-hoc Mode). www. buffalotech. com/wireless PY00-29007-DM20 Rev A 1 2Installation & Configuration Using Web Interface Step Installing the Wireless Ethernet Converter-g Install the Ethernet Converter to a computer by connecting one end of the included Ethernet cable into an available Ethernet port on your computer and the other end to the Ethernet Converter. Ethernet ports are usually located in the rear of the computer. [. . . ] Enter 255. 255. 255. 0 into the Subnet Mask field. Click Apply Now. OS9 - Open your Control Panels and select TCP/IP. Set Connect via to Built-in Ethernet Set Configure to Manually Enter 1. 1. 1. 2 into the IP Address field. Enter 255. 255. 255. 0 into the Subnet Mask field. Close and Save. 3 Step Connecting the Wireless Ethernet Converter to the AirStation. Open your Web browser 4. 5 or later and enter 1. 1. 1. 1 into the URL field. The login screen will open. Click OK The main configuration screen of the 54Mbps Ethernet Converter will open. Click Search in the ESS-ID (SSID) field. 4 The Ethernet Converter will scan for available wireless networks. Select the SSID (ESS-ID) of the AirStation or other Wi-Fi access point to associate with and click select. If encryption is used, select the Encrypt button and select ASCII or HEX and enter the WEP password. Click Set to Connect. The Ethernet Converter is now associated with the Local Area Network. All settings will be retained by the Ethernet Converter when moved between different computers and peripherals. Some screens may vary from those shown in this guide, depending on the operating system used. By accepting the default configuration settings, the Ethernet Converter Manager should discover and configure properly. For more information about configuring and operating your Wireless Ethernet Converter, refer to the User Manual on the Utility CD or the Buffalo Support Web Site: http://www. buffalotech. com/wireless/support. 5 Windows Step Reset the TCP/IP settings of your computer Open your network properties. Connect Using should be set to use your active Ethernet NIC Card. Click Properties Select Obtain and IP Address Automatically. Click OKagain under the Network Properties window. [. . . ] This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. R&TTE Compliance Statement - See owners manual for complete statement This equipment complies with all the requirements of the DIRECTIVE 1999/5/EC OF THE EUROPEAN PARLIAMENT AND THE COUNCIL of 9 March 1999 on radio equipment and telecommunication terminal Equipment and the mutual recognition of their conformity (R&TTE). Copyright © 2003 Buffalo Technology, Inc. [. . . ]