User manual BUFFALO WLI2-CB-G54L

[. . . ] Wireless 54Mbps Notebook Adapter WLI2-CB-G54L User Manual PY00-30042-DM20-01 Installation / Setup 802. 11g Wireless 54Mbps Notebook Adapter 1. Installing the Wireless 54Mbps Notebook Adapter Drivers: Insert the AirNavigator CD into the CD-ROM drive of the PC. The Air Navigator Setup Wizard launches automatically. If the Air Navigator Setup Wizard does not launch automatically, launch the wizard manually by selecting Start>>Run to open the Run dialog box. [. . . ] You can press the 'X' on the client manager to close the screen. You may now access the network and/or Internet through a secure wireless connection. 27 Specifications Wireless LAN Interface Standards Compliance Communication Protocol Frequency Range Transmission Rate Access Mode Security IEEE802. 11g Direct Sequence Spread Spectrum (DSSS), Half Duplex 2. 412-2. 462Mhz 802. 11g: 1, 2, 5. 5, 11, 18, 24, 36, 48, 54Mbps (Auto) Infrastructure mode, Ad-Hoc 128/64 Bit WEP, WPA-PSK, (TKIP, AES) Others Interface Power Consumption Environmental Operation Card Bus 1100mw 0-55ºc, 20-80% (non-condensing) 28 Specifications Communication Range Speed 54Mbps 11Mbps 1Mbps Indoor 165 ft. Wireless connections may be affected as physical conditions and circumstances vary. 29 Troubleshooting / FAQ Troubleshooting / FAQ Use this section to locate answers to frequently asked questions. What should I do if I already have a version of Client Manager on my PC? Update your Client Manager to the version on the CD. If you do not update your Client Manager, there could be a loss of functionally, as some versions of Client Manager will not work properly with the G54 Wireless 54Mbps Notebook Adapter. Before updating Client Manager, you must uninstall all previous versions of Client Manager. To update your Client Manager, load the Air Navigator CD and select Install Client Manager. Why won't all my network clients work? Some operating systems support only a limited number of network clients. Windows 98SE/Me: These operating systems support only four network clients. If you install more than four network clients, only the first four clients you install will work. Will Client Manager support all operating systems? Client Manager and the G54 Wireless 54Mbps Notebook Adapter currently support only Windows 98SE/ME/2000/XP. They do not currently support Windows NT, Mac OS, or Linux. For more information, refer to the Mac OS and Linux page in the Troubleshooting section of this help file. 30 Troubleshooting / FAQ Why won't Client Manager function properly? Windows XP ­ The Wireless Zero Configuration Service conflicts with Client Manager. Select Start»Control Panel»Administrative Tools»Services to open the Services window. Select Disabled in the Startup Type field of Wireless Zero Configuration Service to disable the Wireless Zero Configuration Service. I have more than one Air Navigator CD. You receive the same Air Navagator CD with each Buffalo Technology access point and wireless adapter. Please use the CD with the highest revision number on it. 31 Glossary 10BaseT or 100BaseTx: 802. 3 based Ethernet network that uses UTP (Unshielded twisted pair) cable and a star topology. 802. 1x: The standard for wireless LAN authentication used between an AP and a client. 802. 1x with EAP will initiate key handling. Ad-Hoc Network: The wireless network based on a peer-to-peer communications session. Bandwidth: The transmission capacity of a computer or a communication channel, stated in Megabits per second (Mbps). BSS (Basic Service Set): An 802. 11 networking framework that includes an Access Point. Bus Mastering: A system in which the specified Input/Output device (e. g. NIC Card) can perform tasks without the intervention of the CPU. Client: A PC or workstation on a network. 32 Cross-Over Wiring: A UTP cable that has its transmit and receive pair crossed to allow communications between two devices. [. . . ] EU countries not intended for use None 41 FCC / CE / R&TTE Potential restrictive use This device is a 2. 4 GHz wireless LAN transceiver, intended for indoor home and office use in all EU and EFTA member states, except in France, Belgium and Italy where restrictive use applies. In Italy the end-user should apply for a license at the national spectrum authorities in order to obtain an authorization to use the device for setting up outdoor radio links. In Belgium there is a restriction in outdoor use. The frequency range in which outdoor operation in Belgium is permitted is 2460 ­ 2483. 5 MHz. [. . . ]