User manual BUFFALO WS-QL : TERASTATION™ WINDOWS STORAGE SERVER SETUP MANUAL

[. . . ] Notes: Only replace drives with genuine Bu alo OP-HD series hard drives of the same size. You may always shut the TeraStation down before swapping drives if desired. Hot-swapping is only allowed for a failed drive with a ashing red LED. [. . . ] Hot-swapping is only allowed for a failed drive with a ashing red LED. Before removing a good drive, shut down the TeraStation. Error LED Status LEDs 1-4 Replacing a Damaged or Failed Drive Handle the TeraStation carefully. Before removing any drives, touch the metal back of the TeraStation to dissipate any static electricity. Replace failed drives with new Bu alo OP-HD series drives only. Do not replace a failed drive with a drive that has previously been used in another TeraStation or a computer. If you do, you may lose all data on your other drives. Do not change the order of the hard disks. Note: Previously recognized drives are greyed out. Squeeze the latch to the left and then swing the lock out to the left. latch atch 33 2 2 11 Remote Desktop 16 17 10 Once the lock has swung out 45°, slide the drive cartridge out. When "Hard disk is recognized" is displayed, click [OK]. Right click on [My Computer] and select [Manage]. Remote Desktop 18 Select [Disk Management]. Remote Desktop 11 Insert the replacement drive with the lock open. 19 Right-click on the new drive and select [Initialize Disk]. Step through the wizard to initialize the drive. Insert the drive with the lock open. Remote Desktop 12 Press the latch until it clicks. 20 Right-click on the new drive and select [Convert to Dynamic Disk]. You may now con gure RAID arrays with this disk. Remote Desktop atch latch 21 13 14 Close the front cover. If the TeraStation was o , press the power button to turn it on. Start the "RAID Builder" as in steps 1-5. Create a new volume Right click on the dynamic disk and select [New Volume]. Step through the wizard to create a new volume. To restore a RAID volume (RAID resynchronization) 1 Right-click on the volume labeled "Redundancy Failure", then click on [Restore Volume] from the displayed menu. [. . . ] Start the "RAID Builder" as in steps 1-5. Create a new volume Right click on the dynamic disk and select [New Volume]. Step through the wizard to create a new volume. To restore a RAID volume (RAID resynchronization) 1 Right-click on the volume labeled "Redundancy Failure", then click on [Restore Volume] from the displayed menu. [. . . ]