User manual BURLEY DLITE

[. . . ] d'Lite Owner's Instruction & Safety Manual Contents Introduction 2 I. Hardware Bag Contents and Tool List 3 II. Installing the Quick-Release Levers 4 IV. Unfolding and Folding Your Burley d'Lite 6 VI. [. . . ] Snap the fabric tail gate and splash guard to the snap studs on the side rails if you haven't already done so. NOTE: It's easier to snap these when the trailer is folded; they can remain snapped in place during folding and unfolding. 15 Burley d'Lite Owner's Instruction and Safety Manual Installation and Use of the Cover Your d'Lite Big Screen 2-in-1 Cover is held in place by six snaps at the rear and top, and front. Always use your cover to keep debris out (and toys inside) of the trailer when it's in use. To install the cover, unfold it and snap the top two snaps first. Next, pull the cover toward the back of the trailer and snap the two rear snaps. Finally, using the B-tabs in front, pull the cover taut and affixing the snaps to the front corners. Folding and Stowing the Front Window Folding and stowing the front window is quick and easy. Next, fold the window in half toward the back of the trailer. Then roll the window up toward the top of the trailer. Hold the window in place by inserting the elastic straps into the Velcro holders on the top of the trailer. Using the Adjustable Sunscreen Your Burley d'Lite is equipped with an adjustable sunscreen to keep your kids in the shade during bright, sunny days. To move the adjustable sunscreen, simply pull on the tabs to move it up or down on the trailer as necessary. If more visibility is required, pull the sunscreen up in the middle. This is depicted in the illustration at right. Light Installation To make your trailer more visible, clip a light into the light-holder tab sewn on the upper part of the back of your cover. There are several brands of inexpensive clip-on lights that will make your trailer more visible to motorists and other cyclists. Please go back over these directions and recheck your work. For increased security and safety, Burley offers a clear front and red rear LED light package. These lights mount directly in the place of the left hand side reflectors. See your Burley dealer for details. 16 Burley d'Lite Owner's Instruction and Safety Manual IMPORTANT: Read and study sections "IX. Hitching the Burley d'Lite to Your Bicycle, " "XI. Safety Checklists" before using your Burley d'Lite. IX. Hitching a Burley d'Lite to Your Bicycle The trailer hitch was designed to quickly and safely attach to virtually all types of bicycles. It is inserted in front of the left rear dropout of your bicycle. Hitching the Trailer to Your Bicycle 1. Loosen the knob on the eyebolt until the two arms are spread fully apart. Slip the lower hitch arm under the chain stay (A) and the upper arm above the seat stay (B). [. . . ] Watch out for parked cars and opening doors. Never run stop signals, and never ride against oncoming traffic. On bike paths, give audible warning when passing pedestrians from behind. If you are not aware of your local and state bicycle regulations, contact your nearby police or motor-vehicles office for more information. [. . . ]