User manual BURLEY SOLO WALK N ROLLER

[. . . ] When loaning or selling your trailer, supply the new user with both this Supplement and the original Owner's Instruction & Safety Manual for your trailer. They must familiarize themselves with all sections, especially with Safety Guidelines and Safety Checklists prior to use. If you do not have a copy of the appropriate manual, contact Burley at www. burley. com or call (800) 311-5294 II. Preparation for Installation The Walk'n Roller requires the assembly and attachment of the stroller wheel. [. . . ] · Push the bolt through the hole at the bottom, visible in the cavity underneath, and then secure with the new locking nut provided (tighten to 6 ft-lbs). · The end of the bolt should be flush with, or completely pass through the end of the nut. · Place the 1 inch bolt (#2), using 2 washers as shown and a locking nut. Then place the other 1 inch bolt (#3), through one washer and the remaining hole. · On the underside of (#3) place the safety strap and a locking nut. Tighten to 6 ftlbs using the torque wrench, the end of the bolt must be flush with or completely pass through the nut. The bolt must go through the hole in the flexible coupling; otherwise, hitch could come loose causing an accident resulting in serious injury or death. Burley Solo Walk `n Roller Instruction Guide: Models `04 and Beyond 5 When installed the hitch is re-attached by the bolt that goes through the tongue (and hitch's flexible coupling); the safety strap is anchored, and the d-ring is on top. Note: If using the Burley Alternative hitch, the flexible coupling is attached in the same manner, using the bolt through the tongue. The safety strap is anchored in the same way, to the wheel assembly clamp bolt. IV. Using the Walk n' Roller Wheel The wheel must be placed in the up position in order to attach the trailer to a bicycle. The conversion from "bike" (up) position, to "stroll" position, is quick and requires no tools. To covert from "stroll" to "bike" loosen the , Knob (#1), turning counterclockwise, until the triangular pivot section (#2), can be rotated. Rotate the section bringing the wheel up until the word "bike" appears. With the word "bike" in view, line up the triangular sections and then tighten the knob by hand. Use the similar procedure for converting back to "stroll" position. 2 1 6 Burley Solo Walk `n Roller Instruction Guide: Models `04 and Beyond Using your Walk n' Roller, bicycling with a trailer, and bicycling in general can be hazardous. Failure to obey the following Safety Guidelines could result in serious injury or death. V. Safety Guidelines · · · · · · · · · · · · · · Walk n' Roller must be operated by a responsible adult. Do not wear roller or in-line skates, as you may lose balance or be unable to emergency stop. Check handle is secure, with button protruding through handle receivers. Always wear wrist tether and hold securely onto handle when jogging or strolling. Set parking brake before release of handle to prevent loss of contol. Do not stroll with or jog with headphones, radios, cell phones, or other distractions as you will be unable to hear oncoming vehicles or other hazards. [. . . ] This can be done while you wait by your local bike shop or gas station. 1 Inspect handle, receivers, parking brake and wheel pivot monthly. Replace any loose or damaged parts. Burley Walk n' Roller Limited Warranty Burley will repair or replace any Walk n' Roller parts it determines to be defective for the life of the trailer. The owner of a Burley trailer with Walk n' Roller parts installed must present the trailer for repair at an authorized Burley dealer, together with an original sales receipt or similar proof of purchase. This warranty applies to the original owner and is non-transferable. [. . . ]