User manual BUSHNELL HOLOSIGHT XLP 53-0021

[. . . ] The Bushnell® Holosight® XLP is designed to maintain constant brightness at a particular setting even as the batteries drain through normal use. The reticle brightness will not fade gradually as the batteries drain, but will shut down abruptly. The first indication of the batteries draining is the reticle image blinking when the unit is turned on (see Electronic Features Section). Another indication of low batteries is the reticle image blinking off and on during recoil. [. . . ] When the sight is turned ON, the brightness intensity level is at Level 10. Auto Shutdown The Bushnell® Holosight® XLP is equipped with an auto shutdown feature and will automatically shut itself OFF 8 or 4 hours after the last push-button control is used. This is determined by the method used to turn it ON in step 1. MOUNTING The Bushnell® Holosight® XLP is equipped with mounting hardware to attach to a Weaver-style rail or to a 12 gauge model 1100, 870 or 1187 Remington® shotgun. To achieve the best results and accuracy, the Bushnell® Holosight® XLP must be mounted properly. For the Weaver-style rail mount, the base must be parallel to the bore to achieve the maximum elevation and windage adjustments. 4 5 To mount the sight to a Weaver-style rail, follow these steps, refer to Figure 3: 1. Loosen the 7/64" hex retainer screw that secures the clamp. Place the sight onto the rail such that the unthreaded portion of the cross bolt is fitted into a groove on the top of the Weaver-style rail. The user's preference and the firearm will determine the optimal front to back position on the rail. With the cross bolt inserted fully into the rail's groove, push the sight as far forward as possible. Tighten the hex retainer screw to draw the retainer nut into secure and fully seated contact with the opposite side of the rail. FIGURE 3 NOTE: Loosen the retaining screw just enough to mount or remove the sight. It is not necessary to remove the screw completely, as the lock hardware will not be retained in the sight and could be lost. To mount the sight to a 12 gauge Remington model 870, 1100 or 1187 shotgun, follow these steps, refer to Figure 4: 1. Remove the two through-pins from the shotgun. Remove the two 1/8" hex retainer screws from the sight. Re-install the two hex head screws through the sight and shotgun. Tighten the two hex retainer screws to secure the sight to the shotgun. FIGURE 4 6 7 BORE SIGHTING AND ZEROING Bore sighting is a good preliminary procedure in achieving proper alignment of your sight to the firearm. If the sight is to be mounted to a Weaver-style rail, it is imperative that the base be parallel to the bore. Any major elevation adjustments may be accomplished by shimming the Weaver-style rail. It is important not to use the elevation adjustment of the sight for major adjustments. [. . . ] Turn the sight off immediately and discontinue use until repaired. WARRANTY / REPAIR TWO-YEAR LIMITED WARRANTY Your Bushnell® product is warranted to be free of defects in materials and workmanship for two years after the date of purchase. In the event of a defect under this warranty, we will, at our option, repair or replace the product, provided that you return the product postage prepaid. This warranty does not cover damages caused by misuse, improper handling, installation, or maintenance provided by someone other than a Bushnell Authorized Service Department. Any return made under this warranty must be accompanied by the items listed below: 1) A check/money order in the amount of $15. 00 (USD) to cover the cost of postage and handling 2) Name and address for product return 3) An explanation of the defect 4) Proof of Date Purchased 5) Product should be well packed in a sturdy outside shipping carton, to prevent damage in transit, with return postage prepaid to the address listed below: IN U. S. A. [. . . ]