User manual BUSHNELL IMAGEVIEW

[. . . ] Press the SNAP button once more to format the card. Note that this will erase all files-be sure to backup your photos before re-using an old card. if no card is inserted, the camera will store photos in its 6MB internal memory. When the internal or card memory is full, and can hold no more photos, the display will indicate "FUL. " 3) Press and release the MODE (Power) button to turn on the camera. [. . . ] Mac and Mac OS are trademarks of Apple inc. , registered in the U. S. and other countries. Downloading Your Photos (continued) 3) After the photos are copied to your hard drive, you can disconnect the camera. (On Mac computers, drag the "disk" that appeared on your desktop when the camera was connected into your Trash to "eject" it before disconnecting. ) 4) the jpg standard files from the imageView may be edited with any photo software you choose to use. Photos may also be downloaded by removing the card and using any USB card reader with an SD slot. the distance between the eyes, called "interpupillary distance, " varies from person to person. to set the hinge for your personal iPD: Hold the binocular in the normal viewing position, with a firm grip on each side. Move the barrels closer together or further apart (Fig. 2) until you see a single circular field. Always re-set your binocular to this position before using. Adjusting the Binocular IPD Fig. 2 Eyecups the imageView binocular is fitted with rubber roll-down eyecups designed for your comfort and to exclude extraneous light. if you wear glasses, roll down the eyecups. this will bring your eyes closer to the binocular lens so you can view the entire image without any cutoff. 7 As individual eyesight varies from one person to another, your binocular has an adjustable diopter feature which allows you to fine-tune the binocular to your vision. to set the diopter and focus the binocular: 1) Adjust the hinge for your interpupillary distance as described in "Adjusting the Binocular iPD. " 2) Set the "diopter adjustment" to zero (by rotating the right eyecup) (Fig. 4) Using a lens cover or your hand, cover the objective (front) lens of the right side of the binocular. 5) Using the center focus wheel, focus on a distant object with fine detail (e. g. , brick wall, tree branches, etc. ) until it appears as sharp as possible through the left side of the binocular. 6) Uncover the objective lens on the right side, cover the left objective lens, then view the same object. 7) turn the "diopter setting" adjustment ring, until the object is sharp for your right eye. Caution should be used as over turning or forcing the diopter eyepiece may damage the binocular. 8) Your binocular should now be adjusted for your eyesight. Focus at any far or near distances can now be attained simply by turning the center focus wheel. Make a note of your diopter setting for reference. Focusing/Diopter Adjustment Fig. [. . . ] However, there is no guarantee that interference will not occur in a particular installation. if this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ]