User manual BUSHNELL NIGHT VISION 26-2440

[. . . ] 3) · First, adjust the Objective Lens to as shown in picture 3. · While looking at a distant object (at least 82 ft. /25m away), adjust the Eyepiece Focusing Ring for the sharpest image. · Once the Eyepiece Focusing Ring is adjusted, you only have to adjust the Objective Lens as needed. 3 TROUBLESHOOTING Spots in the Image. You may see spots in the image. [. . . ] This is a Generation I device. Image is not focused. Adjust the focus on the Eyepiece. You must be at least 4. 4 ft. /1. 3 meters from the subject you are viewing. If no improvement, clean lenses, they may be foggy or dusty. (See To Focus). Visibility decreases or disappears. Bright light sources such as headlights may cause visibility to degrade or disappear completely. Turn the scope away from the light source. The unit will restore itself in 1 or 2 minutes. Squeeze and release the Power Lever to reactivate the scope. Conditions such as fog or extremely dark environments will decrease visibility. Scope flashes. The scope may flash when used in a bright environment. It may also flash during the first few seconds of use in dark environments. Illuminator Battery Chart · · · · · Duracell DL 1/3N Eveready 2L76 Kodak K58L Sanyo (other) CR 1/3N Radio Shack 23-265A USER'S GUIDE Batteries · Model 26-2440 Night Vision Scope utilizes a self energizing power supply and does not require batteries. The IR Illuminator requires a 3 volt battery, see list below. Using The Power Lever (See pic. 1) · Never turn the scope on in daylight conditions with the lens cap off. The pinhole in the lens cap allows you to test the scope in daylight conditions. · To activate the scope, squeeze and release the Power Lever, located on the top of the scope. · The image will eventually fade out, this is normal and not a defect. Squeeze the Power Lever again to reactivate the scope. CARE & MAINTENANCE · When not using for an extended amount of time, store the product in a dry location. · Avoid turning the product on in extremely bright light conditions. [. . . ] In the event of a defect under this warranty, we will, at our option, repair or replace the product, provided that you return the product postage prepaid. This warranty does not cover damages caused by misuse or improper handling, installation or maintenance of the product. ® Any return made under this warranty must be accompanied by the items listed below: 1) A check in the amount of $15. 00 to cover the cost of handling 2) Name and address for product return 3) An explanation of the defect 4) Product should be well packed in a sturdy outside shipping carton to prevent damage in transit and return postage prepaid to the address listed below: IN U. S. A. Send To: Bushnell Performance Optics 8500 Marshall Drive Lenexa, Kansas 66214 IN CANADA Send To: Bushnell Performance Optics 25A East Pearce Street, Unit 1 Richmond Hill, Ontario L4B 2M9 For products purchased outside the United States and Canada please contact your local dealer for applicable warranty information. [. . . ]