User manual BUSHNELL TRAIL SENTRY

[. . . ] Congratulations on your purchase of the Bushnell® Digital Trail SentryTM Camera!This weatherproof, rugged trail camera is designed to record still images or movie clips of outdoor wildlife activity. This instruction manual will help you understand, setup, and use your Sentry to achieve the best possible results. If you've been looking for a digital game scouting or surveillance camera that has all the essential features but without the unwanted frills, expense, or confusing operational menus of some less effective off-brand "game cams", the Bushnell Trail Sentry will end your search. [. . . ] Standard Flash--Xenon Flash used for low light photography. Dependent on temperature, number of images and number of flashes during that time. setup--Using the display menu and buttons to set the date/time , still photo or movies , and password. Security (2 methods)--One of the most important requirements of any trail camera. the Trail Sentry has levels-- padlock tab and software password. Trigger Speed--Time delay between a subject passing in front of PIR sensor and the image capture of that subject. All Bushnell Trail Cameras have a trigger speed of less than one second. Open the Sentry by pulling out on the two latches on the right side. Install 4 "D" cell batteries (flat base of all batteries contacting springs), and insert an SD card (not included, use any capacity from 16MB to 1GB. ) in the slot to the right of the 5 buttons as indicated on the slot cover (upside down, with the notched corner of the card on the left and metal contacts of the card facing the back of the slot). Press the card down until you hear it click into place. If the Sentry is turned on without a card in place, it may not turn off-reset it by pulling one of the batteries out partway, insert a new or empty SD card, and put the battery back in place. Only remove or insert cards with power off. The display will show four "dashes", then change to "HHHH" with a blinking key icon below it (Fig a). This is a prompt to enter your password, which can be changed in the setup menu. The first time the camera is turned on, the password is the default, "0000". Press the Enter button four times to enter four zeros (b) (if you previously changed the password in the setup menu, use the UP/DOWN buttons to enter your password digits, pressing ENTER after each one. ), then press it again to confirm-the display indicates "PASS" and the camera is ready to operate. If the wrong password is entered, the display will flash "ERRO" and the camera will not work or allow the password to be changed. After an incorrect password is entered for the third time, the Sentry will automatically turn off. Power must be turned on again before beginning a new password entry cycle. If you are using the camera for the first time, you should set the date and time so your photos will be "stamped" correctly. [. . . ] Motion LED lights when activity is detected by the sensor in regular imaging mode and during setup mode for aiming. Comes complete with aircraft aluminum security cable, padlock, and tree bracket. 0MP Trail Scout plus Night Vision and more, this is the top of the line digital trail camera. Still photos are stored with 5 megapixel resolution (via software processing), and the video clips are recorded with audio captured by a built-in microphone. [. . . ]