User manual CALOR DR8085C0 ACCESS STEAM

[. . . ] · Before using the appliance, check that the mains supply voltage corresponds to the voltage indicated on the rating plate. Connect the appliance to an efficiently earthed power supply and sockets with a minimum current rating of 10 A only. · If the socket and power cable plug are incompatible, the socket should be changed by a qualified professional only. · The safety of this appliance is guaranteed only if correctly connected to an efficient earth system as specified by current electrical safety standards and regulations. [. . . ] · The steam generator should be placed on a flat surface extremely resistant to high temperatures. · The iron must be used and rested on a stable surface. · When placing the iron on its stand, ensure that the surface on which the stand is placed is stable. This appliance complies with directive 89/336/EEC on radio interference suppression. 9 DESCRIPTION 1) Steam button lock (certain models only) 2) Steam discharge button 2A)Steam discharge trigger (certain models only) 2B) Steam discharge wheel with top and bottom activation and end lock for continuous delivery (certain models only). 3) Iron thermostat knob 4) "Iron at temperature" indicator light 5) Cable wands 6) Iron rest 7) ON/OFF switch 8) Cable winder (certain models only) 9) Housing for cable wands 10) Steam regulation knob 11) "No water" indicator 12) Water fill door 13) "Steam ready" indicator light 14) Sole plate for delicate garments (certain models only) 15) Antical System USEFUL TIPS · The original appearance and softness of fabrics such as velvet or wool, or gloves, bags etc. can be restored by passing the iron a short distance away with the steam jet in operation. · To remove the marks left by furniture and restore carpets to new, allow the steam to penetrate into the flattened pile and brush lightly. · Do not rest or use the iron on zips, hooks, rings etc to avoid scratching the plate. · Keep the surface of the plate clean. To clean, when cold, wipe the surface with a damp cloth. The iron must never be treated with descaling products. Important: during ironing, the wand fixed to the base of the control unit could become hot. Do not touch! INSTRUCTIONS STEAM IRONING Before steam ironing, make sure the fabric is suitable for this kind of ironing. The machine works with normal tap water. In case of very hard water (hardness above 27°F) we suggest using 50% demineralised water and 50% tap water. Never use chemical substances or detergents (eg perfumed water, essences, descaling solutions, etc) or mineral water. Filling the tank and connecting to the mains Make sure the power cable is unplugged from the mains socket. Lift the fill door (12) using the special tab. Top up until you see water appear in the filling area (fig. 7 Position the thermostat regulation knob (3) in the area indicated in the figure according to the type of fabric to be ironed (fig. Wait for the "steam ready" (13) and "iron at temperature" (4) lights to go out before starting to iron. NB: both indicator lights will go on and off during ironing, according to the temperature reached by the steam generator and iron. [. . . ] If you top up too late (more than 2 minutes), the system will stop discharging steam. Once the level of water in the tank has been topped up, the appliance will operate as if turned on for the first time. Steam will be ready in 5 minutes and during these 5 minutes you can hear the pump fill 4 or 5 times for about 30 seconds. The steam generator is now stabilised and will operate as normal, filling the water every now and then. [. . . ]