User manual CAMBRIDGE AUDIO AZUR DVD86

[. . . ] Level calibration. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 4. Source setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 5. Assigning video sources . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 Surround sound modes. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 Operating instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17-20 Decode modes - 5. 1 speaker setup. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 Decode modes - 6. 1 speaker setup. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 Audio split mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21 Bass/Treble configuration. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21 Subwoofer setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21 Advanced bass management . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21 OSD setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22 Custom installation use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22 Reset/Back-up memory . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22 Troubleshooting. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 Technical specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 Visit www. cambridge-audio. com and register to receive notification of future hardware and software releases. This guide is designed to make installing and using this product as easy as possible. [. . . ] DVI switching can be supported simply by using DVI to HDMI adaptors as these two connection types are compatible. When using DVI only video will be passed to the TV/Monitor. Again a Co-axial (SPDIF) or Optical (Toslink) digital audio connection must be made from each source to the 540R v3 for it to be able to receive audio and decode surround sound etc. Tuner S-Video Manufactured in an ISO9002 approved facility TV/Mon Out Video In In 1 (Assignable) In 2 CD Digital Optical In Video 1 Video 2 DVD Optical Out Do not obstruct ventilation. Ventilation nicht verschließen. Component Video In In 1 (Assignable) TV/Mon Out In 2 Component Vide Out FM 75 Cr/Pr Cb/Pb Y Cr/Pr Cb/Pb Y Cr/Pr Cb/Pb HDMI cable N1863 Composite Speaker Impedance 4-8 Ohms CD Video 1 Video 2 DVD Sur Left Left In 1 (Assignable) In 2 Normal Update AM Loop 300 RS232C Digital Coax In Coax Out A46 IR Emitter L SL C SB C SL L Sur Right Right L In DVD player with HDMI output R This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference; 2) This device must accept any interference, including interference that may cause undesired operation. Sur Back In Out Centre CD/Aux Video 1 Video 2 DVD HDMI Audio In Tape/MD/CDR Serial No. label fitted on underside R SR SW SB SW SR R 6. 1 Direct In 6. 1 Preamp Out 6. 1 5. 1 OR Example: HDMI DVD player assigned to DVD input. 10 azur 5. 1/6. 1 Direct in DVD-A or SACD players etc can be connected to the 540R v3 via its 5. 1/6. 1 Direct inputs allowing multi-channel music playback from these sources. DVD-A and SACD both support 5. 1 analog output. The 540R v3's direct inputs also allow optional connection of Surround Back or Surround Left and Surround Right signals for compatibility with future 6. 1 sources or external decoders. To select the Direct Input press the 6. 1 Direct button on the front panel or remote. Note: These connections are pure analog for best sound quality and no DSP processing or Bass and Treble adjustment by the 540R v3 is possible. 540R v3 ENGLISH 6. 1 Preamp out To connect external power amplifiers, use Phono/RCA leads connected to the 6. 1 Preamp Outputs on the rear panel. For 5. 1/6. 1 use, set the `Preamp Out' setting in the `Output Setup' OSD menu to `Pre Out' rather than `Normal'. Assigning video sources 5 4 Subwoofer For improving the bass in your system, as well as reproducing dedicated LFE cinema effects when playing Dolby Digital or DTS encoded discs. Your subwoofer can often be placed almost anywhere in the room as bass is less directional, but experimentation with positioning is recommended. Surround Back Centre speaker Sixth channel speaker required for enjoying Dolby® Digital EX or DTS®-ES or other 6. 1 audio. Improves the quality of sound effects by filling the gap between the surround left and rear right speakers. Position the speaker firing towards the front of the room. 1. Speaker configuration First decide what kind of speaker package you would like to use. Refer to the diagrams below for typical examples of 5. 1 and 6. 1 loudspeaker setups. Always adjust the speaker and listening positions until you are happy with the sound. Please refer to the loudspeaker and subwoofer manuals for more detailed positioning information. 1 2 1 In each case the 5. 1/6. 1 in fact relates to the maximum number of speakers that can be used, as the Centre, Sub and Surround speakers can all be deleted if required (although of course performance is reduced). For example, if you choose not to use a Centre Channel speaker you can set this to `None' in the settings as shown later and the 540R v3 will automatically redirect the centre channel audio information into the Left and Right Front channels, creating what is known as a `Phantom Centre'. Similarly, you might decide not to use a subwoofer if your main Left and Right speakers are capable of reproducing enough bass for a satisfying music/movie experience. The 540R v3 will then automatically re-direct the bass from the Subwoofer/Low Frequency Effect channel to the Left and Right Front Speakers. [. . . ] Repeat this procedure with the Mute, Sub On/Off, Stereo Mono and Tuner FM/AM buttons to send On/Off commands. The Tuner FM/AM button also provides unique FM and AM commands to allow switching to a specific band. A full IR code table and RS232 protocol for this product is available on a the Cambridge Audio website at: www. cambridge-audio. com OSD setup On-Screen Display is available on the Composite and S-Video outputs only. (Not available on Component Video or HDMI. ) Select the `OSD Setup' menu, select `OSD Video' and use the Left and Right arrows to select whether you would like the OSD video source to be Composite or S-Video: OSD Setup Menu TV Format Background OSD Video Language : : : : PAL Blue Composite English Return to Menu : [OSD] The OSD can be shown either on a blue background or overlaid on the analog video. [. . . ]