User manual CAME BRC

[. . . ] The command devices are low voltage and protected by a 1. 6A fuse, whereas the gearmotor and electric lock are protected by 5A fuses. The accessories’ total wattage (24V) must not exceed 40W. [. . . ] The accessories’ total wattage (24V) must not exceed 40W. NB: If an NC safety contact (2-C1, 2-CX, 1-2) is opened, the LED will flash to indicate this fact. optional accessories - Gate open pilot lamp (3W). A lamp that signals the gate’s open position and that goes out when the gate is in the closed position. Powers the reduction gears through batteries in case of a power outage. After the power supply is restored, it also recharges the batteries. The automatic closing timer is automatically activated at the end of ENGLISH the opening cycle. B The first encoding operation must be carried out whilst keeping the J jumpers positioned for channels 1 and 2 as per fig. B for any subsequent settings on different channels. Plantear el código en el dip-switch C y el canal en D (P1=CH1 y P2=CH2, planteamiento por defecto) D P1 P2 1 2 3 4 1 2 3 4 5 6 7 8 9 10 P1 1 2 3 4 1 2 3 4 1 2 3 4 1 2 3 4 CH1 CH2 4 1 2 3 4 CH3 1 2 3 4 CH4 1 2 3 4 C P2 1 2 3 CH1 CH2 CH3 CH4 T434M - T314M P1=CH1 P2=CH2 P3=CH3 P4=CH4 T432S / T432SA vedi istruzioni su confezione see instructions on pack voir instructions sur l'emballage Siehe Anleitungen auf der Packung. ver instrucciones en el embalaje P1 P3 P2 P4 impostare solo il codice set code only ne saisir que le code Stellen Sie nur den Code ein. Plantear sólo el código 1 2 3 4 5 6 7 8 9 10 C TAM T432 T434 T438 vedi foglio istruzioni inserito nella confezione TFM T132 T134 T138 T152 T154 T158 see instruction sheet inside the pack voir la notice d'instructions qui se trouve dans l'emballage Siehe Anleitungen, die der Packung beiliegen. ENGLISH Keep the CH1 key pressed on the base card (the signal LED will flash), and with a key on the transmitter the code is sent, the LED will remain lit to signal the successful saving of the code (figure 1, pag. Perform the same procedure with the "CH2" key, associating it with another transmitter key (fig. [. . . ] Plantear sólo el código 1 2 3 4 5 6 7 8 9 10 C TAM T432 T434 T438 vedi foglio istruzioni inserito nella confezione TFM T132 T134 T138 T152 T154 T158 see instruction sheet inside the pack voir la notice d'instructions qui se trouve dans l'emballage Siehe Anleitungen, die der Packung beiliegen. ENGLISH Keep the CH1 key pressed on the base card (the signal LED will flash), and with a key on the transmitter the code is sent, the LED will remain lit to signal the successful saving of the code (figure 1, pag. Perform the same procedure with the "CH2" key, associating it with another transmitter key (fig. [. . . ]