User manual CAME ZA5

[. . . ] - If the cable is damaged, replace it as soon as possible with another one which has the same characteristics and which is suitable for use at the power level of the appliance. This procedure must be performed by a qualified technician. A) Do not check the status of the filters while the cooker hood is operating B) Do not touch bulbs or adjacent areas, during or straight after prolonged use of the lighting installation. C) Flambè cooking is prohibited underneath the cooker hood D) Avoid free flame, as it is damaging for the filters and a fire hazard E) Constantly check food frying to avoid that the overheated oil may become a fire hazard F) Disconnect the electrical plug prior to any maintenance. [. . . ] € We recommend the use of an air exhaust tube which has the same diameter as the air exhaust outlet hole. If a pipe with a smaller diameter is used, the efficiency of the product may be reduced and its operation may - 11 - become noisier. € Hood assembly Remove the structure from the packaging and remove the 2 screws A to separate the upper part from the lower part (fig. - Position hole template on the ceiling paying attention that the arrow is positioned on the same side as the appliance controls (Fig. Make 4, Ø8 holes in the ceiling and drive in 3 screws without completely tightening them. Pay attention not to insert the screw into the hole marked with an X on the hole template (the screws and expansion plugs must be suitable for the type of wall). - Take the upper part of the structure B (fig. 4) and insert the 3 slots onto the 3 screws that are not completely tightened. Drive in the fourth screw X and tighten the remaining 3 to allow definitive blocking of the upper part of structure B - Take the lower part of the telescopic structure C and insert it into the upper structure B (fig. Adjust the height by referring to the amounts indicated in (fig. The filters are not washable or re-usable and must be replaced at least once every four months. The active carbon filter saturation level depends on the frequency with which the appliance is used, the type of cooking performed and the regularity with which the anti-grease filters are cleaned. € Clean the cooker hood frequently, both inside and outside, using a cloth which has been dampened with denatured alcohol or neutral, non-abrasive liquid detergents. € The light on the cooker hood is designed for use during cooking and not for general room illumination. Extended use of the light reduces the average duration of the bulb. The appliance switches on at speed level 1, If the cooker hood is on depress the push-button for 2 sec. If the cooker hood is at speed level 1 it will not be necessary to depress the push-button to switch the cooker hood off. Display C = indicates the motor speed level selected and activates the timer. Touching the key at 3rd speed, the intensive function runs for 10', then the appliance go back to work at the original speed. During this function the display blinks. [. . . ] - When display item C flashes, at a speed where it USE AND MAINTENANCE • We recommend that the cooker hood is switched on before any food is cooked. We also recommend that the appliance is left running for 15 minutes after the food is cooked, in order to thoroughly eliminate all contaminated air. The effective performance of the cooker hood depends on constant maintenance; the anti-grease filter and the active carbon filter both require special attention. € The anti-grease filter is used to trap any grease - 12 - alternates with the letter A (e. [. . . ]