User manual CAME ZL19

[. . . ] Take care when the cooker hood is operating simultaneously with an open fireplace or burner that depend on the air in the environment and are supplied by other than electrical energy, as the cooker hood removes the air from the environment which a burner or fireplace need for combustion. The negative pressure in the environment must not exceed 4Pa (4x10-5 bar). Provide adequate ventilation in the environment for a safe operation of the cooker hood. Follow the local laws applicable for external air evacuation. [. . . ] Adjust the width of the support bracket of the upper flue (Fig. Then fix it to the ceiling using the screws A (Fig. 3) in such a way that it is in line with your hood and respecting the distance from the ceiling indicated in Fig. Connect the flange C to the air exhaust hole using a connection pipe (Fig. Insert the upper flue into the lower flue. Fix the lower flue to the hood using the screws B provided (Fig. 4), extract the upper flue up to the bracket and fix it with the screws B (Fig. To transform the hood from a ducting version into a filtering version, ask your dealer for the charcoal filters and follow the installation instructions. € Filtering version: Install the hood and the two flues as described in the paragraph for installation of the hood in ducting version. To assemble the filtering flue refer to the instructions contained in the kit. The charcoal filters are already fitted to the appliance (Fig. To activate the function press the “E” button; the decimal point on the display will start to flash. The timer and the intensive function cannot be activated at the same time. The timer does not interact with the lights. To deactivate the function, set the extraction rate level back to “0”. Clean air: The clean air function allows you to run the appliance for about 10 minutes every hour at the lowest extraction rate level to allow for constant circulation of fresh air. To activate the function, press the “E” button for a few seconds with the motor off. Once the function has been activated, the letter “C” will start flashing on the display. To deactivate the function press the “B+D” buttons together. Carbon filter: Carbon filters are used to purify the air which is released back into the room. The filters are not washable or reusable and must be replaced at least once every four months. Saturation levels of carbon filters depend on the frequency with which the appliance is used, the type of cooking performed and how often the anti-grease filters are cleaned. [. . . ] Extended use of the light reduces the average duration of the bulb. • Replacing halogen light bulbs (Fig. 8): To replace the halogen light bulbs B, remove the glass pane C using a lever action on the relevant cracks. Replace the bulbs with new ones of the same type. [. . . ]