User manual CAME ZL80C INSTALLATION MANUAL

[. . . ] Symbol on the product or on the accompanying The paperwork indicates that the appliance should not be treated as domestic waste, but should be delivered to a suitable electric and electronic appliance recycling collection point. Follow local guidelines when disposing of waste. For more information on the treatment, re-use and recycling of this product, please contact your local authority, domestic waste collection service or the shop where the appliance was purchased. Take care when the cooker hood is operating simultaneously with an open fireplace or burner that depend on the air in the environment and are supplied by other than electrical energy, as the cooker hood removes the air from the environment which a burner or fireplace need for combustion. [. . . ] - In the case of assembly of the appliance in the suction version prepare the hole for evacuation of the air. € We recommend the use of an air exhaust tube which has the same diameter as the air exhaust outlet hole. If a pipe with a smaller diameter is used, the efficiency of the product may be reduced and its operation may become noisier. € If the appliance is supplied with the small cupola M remove it by releasing it as indicated in Fig. Before proceeding with the assembly operations, for easier manoeuvrability of the appliance disengage the anti-grease filter by pulling handle B as indicated in Fig. If one owns a model with perimeter suction panel, before carrying out this operation, perform the following phases: - Open panel C as indicated in Fig. - If one owns the version with three A panels release them from the fixing pins by pulling outwards (Fig. 4) and then remove them from safety pins N (Fig. To put them back perform the operation in reverse order. During this disassembly and assembly operation ensure to hold the panel securely to prevent accidental falls. € Wall mounting: Trace the bottom side of the hood on the wall. - Fix the small cupola M and the grille E making sure that is it perfectly hooked on to the fastening pins G (Fig. € Optional accessories: This model may have decorative ducts as optional accessories - ask your retailer for information. Before installing decorative flues it is necessary to remove the small cupola M and loosen the 4 screws Q that lock the fastening pins G as shown in Fig. € Installation of models with decorative ducts: Extractor hood Make sure the electrical power supply is within the measurements of the decorative connector. Adjust the width of the support bracket of the top connector (Fig. Then fix it to the ceiling so that it is on the same axis as the hood using screws A and observing the distance from the ceiling shown in Fig. Connect flange F to the air exhaust hole using flexible hose L (Fig. Slide the top connector inside the lower duct and place this on the body (Fig. Pull out the top duct as far as the bracket and secure it using screws B (Fig. To transform the hood from a ducting version into a filtering version, ask your dealer for the charcoal filters and follow the installation instructions. € Filter hood: Please note: The filters must be ordered from your dealer as an accessory. [. . . ] We also recommend that the appliance is left running for 15 minutes after the food is cooked, in order to thoroughly eliminate all contaminated air. The effective performance of the cooker hood depends on constant maintenance; the anti-grease filter and the active carbon filter both require special attention. € The anti-grease filter is responsible retaining the grease particles suspended in the air, therefore it is subject to clogging with variable frequency according to the use of the appliance. - To prevent the danger of possible fires, at least every 2 months one must wash the anti-grease filters by hand using non-abrasive neutral liquid detergents or in the dishwasher at low temperatures and on short cycles. [. . . ]