User manual CANDY CCT685/1X & CCT685X,MV

[. . . ] if in doubt ask a qualified electrician. - If the cable is damaged, replace it as soon as possible with another one which has the same characteristics and which is suitable for use at the power level of the appliance. This procedure must be performed by a qualified technician. A) Do not check the status of the filters while the cooker hood is operating B) Do not touch bulbs or adjacent areas, during or straight after prolonged use of the lighting installation. [. . . ] - In the case of assembly of the appliance in the suction version prepare the hole for evacuation of the air. € We recommend the use of an air exhaust tube which has the same diameter as the air exhaust outlet hole. If a pipe with a smaller diameter is used, the efficiency of - 18 - the product may be reduced and its operation may become noisier. € FIXING TO THE WALL Drill the holes A respecting the distances indicated (Fig. Fix the appliance to the wall and align it in horizontal position to the wall units. When the appliance has been adjusted, definitely fix the hood using the screws A (Fig. For the various installations use screws and screw anchors suited to the type of wall (e. If the screws and screw anchors are provided with the product, check that they are suitable for the type of wall on which the hood is to be fixed. € FIXING THE DECORATIVE TELESCOPIC FLUE EXTRACTOR VERSION Arrange the electrical power supply within the dimensions of the decorative flue. If your appliance must be installed as an extractor version, make sure an air exhaust hole has been prepared. Adjust the width of the support bracket of the upper flue (Fig. 5 seconds, the carbon filters must be replaced. After the clean filter has been replaced, the electronic memory must be reset by pressing button A for approximately 5 seconds, until the light on the button stops flashing. 9) MECHANICAL the key symbols are explained below: A = LIGHT B = OFF C = SPEED I D = SPEED II E = SPEED III G = MOTOR WORKING indicator •COMMANDS: (pic. 10) SLIDER the key symbols are explained below: A = Light switch USE AND MAINTENANCE • We recommend that the cooker hood is switched on before any food is cooked. We also recommend that the appliance is left running for 15 minutes after the food is cooked, in order to thoroughly eliminate all contaminated air. The effective performance of the cooker hood depends on constant maintenance; the anti-grease filter and the active carbon filter both require special attention. € The anti-grease filter is used to trap any grease particles suspended in the air, therefore is subject to saturation (the time it takes for the filter to become saturated depends on the way in which the appliance is used). - To prevent potential fire hazards, the anti-grease filters should be washed a minimum of every 2 months (it is possible to use the dishwasher for this task). - After a few washes, the colour of the filters may change. This does not mean they have to be replaced. If the replacement and washing instructions are not followed, the anti-grease filters may present a fire hazard. [. . . ] For størst mulig sikkerhed, sørg for en passende ventilation af r ummet. 8) LYSENDE er følgende tegnforklaring gældende: A = tast for BELYSNING B = tast for OFF C = tast for FØRSTE HASTIGHED D = tast for ANDEN HASTIGHED E = tast for TREDJE HASTIGHED F = tast for TIMER AUTOMATISK STOP 15 minutter • Ved at trykke på knappen F i 2 sekunder (ved slukket emhætte) aktiveres funktionen “clean air”. 9) MEKANISKE er følgende tegnforklaring gældende: A = tast for BELYSNING B = tast for OFF C = tast for FØRSTE HASTIGHED D = tast for ANDEN HASTIGHED E = tast for TREDJE HASTIGHED G = Controlelampje dat aangeeft dat de motor in werking is. For sikker bruk må man derfor sørge for tilstrekkelig ventilasjon av lokalet. [. . . ]