User manual CANDY CMDDS 5144WH

[. . . ] 33 Tips for keeping food perfect in the Fridge . 33 If you're not at home for a long time . Before using your refrigerator, please carefully read this instruction manual in order to maximize its performance. Store all documentation for subsequent use or for other owners. [. . . ] , in cold weather condensation may form on the outer surfaces. This is quite normal and is not a fault. Remove the condensation by wiping with a dry cloth. Never place Refrigerator in a wall recessed or into fitted cabinets or fumiture when it is working, the grille at the back may become hot and the sides warm. Do not drape the Refrigerator with any covering. Before you starting to use the freezer, please check that: 1. The interior is dry and air can circulate freely at the rear. Clean the interior as recommended under "TAKE CARE" section (electric parts of the refrigerator can only be wiped by dry cloth). Do not switch on until 4 hours after moving the fridge/freezer. If the appliance is switched off at any time, wait 30 minutes before switching back on to allow the coolant fluid to settle. Before connecting the Refrigerator to the mains supply position. The thermostat control dias is located inside the Fridge compartment. Turn the thermostat knob to the "3" position and turn on the electricity. The compressor and the light inside the refrigerator will begin to work. Before storing foods in your refrigerator, turn the refrigerator on and wait for 24 hours, to make sure it is working properly and to allow the Fridge/Freezer to fail to the correct temperature. Open the door 30 minutes later, if the temperature in the refrigerator decreased obviously, it shows that the refrigerator system works well. When the refrigerator operates for a period of time, the temperature controller will automatically set the temperature within limits it opens. The temperature selector Knob is located on the right hand side wall of the refrigerator interior. Setting "MED": normal operation (adequate for most situations) Setting "MAX": coolest Temperature During high ambient temperature: it may be necessary to set the thermostat to the coolest setting (position "MAX"). This may cause the compressor running continuously in order to maintain a low temperature in the cabinet. For the first time you install your refrigerator, set the thermostat knob at "MED". Give your refrigerator time to cool down completely before adding food. [. . . ] If the problem continues contact the local store where your purchase was made. If the provided plug has been replaced, make sure the new plug is properly connected. If the appliance is still not operating after the above checks, please contact Customer Service. This appliance is marked according to the European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE). [. . . ]