User manual CANDY GCC 780NBT-S

[. . . ] INSTRUCTION BOOK GCC 780NBT Condenser Tumble Dryer English Slovensko Français Dutch Polski 2 16 30 44 58 INDEX Introduction Delivery Information Safety Reminders Use Installation The Laundry Ventilation Environmental Issues Gias Service Installation Electrical Requirements Adjusting the Feet Drain Hose Kit: Fitting Instructions Preparing the Load Clothes Preparation Do Not Tumble Dry Energy Saving Sorting the Load Drying Guide Controls and Indicators Selecting the Programme Door and Filter Opening the Door Filter Filter Care Indicator Water Container To Remove the Container Condenser To Remove the Condenser Operation Delay Start Function Cancelling and Resetting the Programme Cleaning and Routine Maintenance Cleaning the Dryer Technical Specifications Troubleshooting Customer Service Spares Gias Service 3 3 3 4 5 5 6 7 7 7 7 7 8 9 9 9 9 9 9 10 11 12 12 12 12 12 12 13 13 13 14 14 14 14 14 15 15 15 15 EN 2 INTRODUCTION Please read and follow these instructions carefully and operate the machine accordingly. This booklet provides important guidelines for safe use, installation, maintenance and some useful advice for best results when using your machine. Keep all documentation in a safe place for future reference or for any future owners. Delivery Information Please check that the following items are delivered with the appliance: ● Instruction manual ● Guarantee card ● Energy label Check that no damage has occurred to the machine during transit. [. . . ] ALWAYS ● Try to dry the maximum weight of laundry, this will save time and electricity. — Check that the filter is clean before every drying cycle. NEVER ● Exceed the maximum weight, this will waste time and electricity. — Put dripping wet items into the tumble dryer, this may damage the appliance. The standard cycle HANG DRY ( ) is the most energy efficient and best suited for drying normal wet cotton laundry. The table below shows the approximate time and energy consumption of the main drying programmes. cYCLE Perfect Home Store Dry Hang Dry Hang Dry Iron Dry LOAD FULL FULL FULL HALF FULL ENERGY (kWh) 5 , 64 5 , 31 4 , 70 2 , 56 3 , 76 TIME (Min) 204 177 150 87 123 0 , 80 W 0 , 20 W Power consumption of "left on-mode" Power consumption of "off-mode" EN 9 CONTROLS AND INDICATORS Programme Selector Water Tank Indicator Filter Care Indicator Programme Display Time Selection Button Delay Start Acrylic Synthetic Button Button Anti-Crease Button Start/Pause Button Control Panel and Indicator Lights Programme Selector – Select the required programme. Time Selection Button – Allows the user to change duration of the programme selected by Programme Selector. It can be used only with the selection of: Mix&Dry, Shirts and Time Programmes. Delay Start Button – Allows the user to delay the start of the drying cycle (see details of Operation ). Acrylic and Synthetic Button –Press to select the type of fabrics to dry Acrylic and synthetics, when pressed Acrylic Synthetics option is activated and the indicator lights up. Memo Button – Allows user to record the programme by pressing simultaneously the AntiCrease and the Acrylic Synthetic buttons for 3 seconds, after 2 minutes duration of the chosen programme/option. Filter Care indicator – Lights when the filter needs cleaning. Empty Water indicator – Lights when the water container is full. program Display – Related indicator lights when a auto programme has been selected. Refresh – The indicator lights up when the programme starts the cool down stage. SELECTING THE PROGRAMME The Candy Sensor Dry machine gives many options for drying the laundry to suit all circumstances. The table on the next page lists the programmes and the function of each programme. Note: The sensor may not detect a small load of small articles. For small loads and separate items or pre-dried fabrics with low moisture content, use the timed programmes. If the sensor does not detect the item the dryer will only operate for 10 minutes before going into cooldown. If the load is too large or too wet to tumble dry the dryer will automatically go into cooldown after approximately 3 hours. [. . . ] The Indicator is on… ● Does the filter need cleaning?The Indicator is on… ● Does the water container need emptying?Time display to end could change during drying cycle. The time to end is continuously checked during the drying cycle and the time is adjusted to give the best estimation time. [. . . ]