User manual CANNON CANTERBURY FREESTANDER

[. . . ] MAKER'S WARRANTY Cannon FREESTANDER MODELS CANT, CANTLP USER INSTRUCTIONS INSTALLATION INSTRUCTIONS SERVICE INSTRUCTIONS This heater is approved for use with Natural and Propane gases. Please leave instructions with the owner Contents Contents Warranty Safety warnings What to do if you smell gas Warnings Standards User instructions Operating instructions Cleaning Heater specifications Alternative flue Installation instructions Clearances Installation Gas connection Fuel bed & log installation Gas pressure point Flue installation Flue kit Alternative double skin flue installation Alternative flue kit Service instructions General Access to components To replace the gas control To replace the fan To replace the electronic controller To check or change fuse To remove the burner and electrodes Trouble shooting Wiring diagram Authorised service agents 18-20 14-15 10 9 6 2 3 4 2 Warranty The Cannon appliance is warranted against defects in materials and workmanship for a period of one, (1) year from its date of original purchase, for residential use in Australia. Warranty service, which includes parts and labour for the replacement or repair of defective parts, is available through Cannon Authorised Service Agencies. (Please refer to the list of authorised service agents in this manual. ) Consumers are responsible for service person's travel outside normal service areas (approximately seventy (70k) radius from the nearest Cannon dealer's location), local cartage, and normal maintenance as described in this manual. [. . . ] Check the heater is suitable for gas available. (Please dispose of packaging appropriately, keep away from children). Prepare electrical and gas connections, a 10 Amp wall socket needs to be located within 1. 5m of the heater. (Check flue and gas connection positions. Refer to gas connection instructions on page 11 and flue installation instructions on pages 14 & 15 and 16 & 17). Remove the pedestal front by unscrewing two screws either side. Remove the heater front securing screws, one either side. Refer figure 12. 10 11 12 9. Remove the front glass surround by holding it firmly on either side and pulling it towards yourself, see figure 13. 13 10. Remove the inner glass. Slacken off screws in top clamp and remove side clamps. Refer figure 14. 14 Gas connection 11. Connect incoming gas supply pipe to compression fitting at rear of appliance. For inlet position see figure 15. 15 11 Installation instructions continued Fuel bed and log installation 12. The fuel bed is contained within the burner chamber. The fuel bed is retained by a spring clip fixed to the rear of the burner chamber FUEL BED MUST BE HARD UP AGAINST REAR OF BURNER 16 13. Logs are numbered as follows: No 1 - Left front log No 2 - left back log No 3 - Right front log No 4 - Right back log Position the four individually numbered logs in the following order on the fuel bed as shown in figures 17-20. The male locating pins in fuel bed must engage with corresponding holes in the individual logs. a) Place log No. 1 onto the 2 front left pins on the fuel bed, see figure 17. 17 b) Place log No. 2 onto the 2 left back pins. Refer figure 18. 18 c) Place log No. 3 on single right front pin, ensure fork locates over log No. 2, see figure 19. 19 12 d) Place log No. 4 on single right back pin, ensure left side of log rests on depression in No. Refit the inner glass, but do not overtighten the screws. [. . . ] Remove the four M5 screws fixing the burner chamber fascia in position and slide out taking a note of the "P" clip position through which the thermocouple leads are passed. Remove the two M5 screws fixing the burner to the burner chamber fascia. Remove the two 8G self tapping screws fixing the electrodes in position. Replace in reverse order. Troubleshooting Item No 1 2 Check Check 240V power to heater. [. . . ]