User manual CANNON FITZROYIN-BUILT POWERFLUE

[. . . ] Any product subjected to misuse, abuse, negligence, accident or alteration will have its warranty voided. The defacement of serial plate will have its warranty voided. If installation is not carried out in accordance with manufacturer's instructions, this warranty may be void. The customer must keep their "Tax Invoice" as proof of purchase of this product, and compliance certificate as proof of required installation. [. . . ] Refer figure 14. v 14 11 Gas connection 12. Connect incoming gas supply pipe to 1/2" compression fitting at rear of appliance. For inlet position see figure 15. 15 Log installation 13. The burner is contained within the burner chamber. Logs are numbered as follows: No 1 - Left front log No 2 - Left back log No 3 - Right front log No 4 - Right back log Position the four individually numbered logs in the following order on the burner head as shown in figures 17-20. The male locating pins in the burner head must engage with corresponding holes in the individual logs. a) Place log No. 1 onto the 2 front left pins on the burner head, ensuring that the charring faces the front. 17 b) Place log No. 2 onto the 2 left back pins. Refer figure 18. 18 c) Place log No. 3 on single right front pin, ensure fork locates over log No. Refer figure 19. 12 19 Advise the user in the operation of the heater. d) Place log No. 4 on single right back pin, ensure left side of log rests on depression in No. Carry out installation as per figure 26 (ceiling plate installation) and figure 27 (flue installation). Cut a hole 180mm ø in the ceiling in line with the flue position. Secure ceiling plate against the ceiling by bending out the tabs above the ceiling. Note: If the ceiling has an incline, a ceiling box will need to be fitted. The ceiling box is an accessory and can be ordered from the supplier. Installation instructions are supplied with the ceiling box. Part no: BOXFB. 26 Flue kit The flue kit contains: 2 x 900mm lengths of 125mm ø painted upper flue 1 x 900mm painted bottom flue spigot 1 x 900mm length of 125mm ø plain flue 1 x ceiling ring 1 x 125mm AGA approved gas cowl 16 27 17 Service instructions. (Do not modify this appliance). General 1. Service work to be carried out by an authorised service person only. Unplug from wall socket or turn off power at main switchboard if heater is hard wired. Always shut off the gas supply and ensure that the heater is cool before commencing any service operations. [. . . ] A positive check is to use a jumper wire and connect one end of the earth and hold the other end with insulated pliers 4mm from the spark generator on the module. If there is no spark to earth then change the module. Check the spark ceramic insulator for signs of cracks. · Check that the wall socket to the appliance has correct polarity. [. . . ]