User manual CANNON THERMOSTAT

[. . . ] THERMOSTAT USER MANUAL ROOM TIME UP A/M T OK DOWN P PWR Cannon CONTENTS Quick start guide. Safety warnings Features Thermostat LCD Functions Button functions Programming button functions Initial setup On / Off Time and day of the week Manual mode Automatic mode Programming Programming screen displays Program mode Factory default settings Your settings Settings Change between C° and F° Restore factory default settings Teaching the thermostat ID code to the control unit Frequently asked questions Quick reference table Back Up Switch Service Battery type: 2 X AA batteries Battery life : approximately 12 months Transmission frequency: 433. 92 Mhz Dimensions: 140MM x 80mm x 20mm Page 1. 2 3 4 5 6 -7 8 9 9 11 -10 12 13 14 ROOM 15 16 17 TIME UP A/M T OK DOWN P PWR 18 Cannon QUICK START GUIDE This Remote Thermostat is a room thermostat and to function correctly it should be located in the same room as the heater within personal comfort zone. Select "PWR" and "OK" buttons and press them together (then release). Select Auto or Manual by pressing "A/M" button (then release). [. . . ] Press and release the `UP ' or `DOWN ' button to increase or decrease the hour setting by 1 hour. Press and hold the `UP ' or `DOWN ' button for 2 seconds or longer to increase or decrease the hour setting by 1 hour every 0. 5 seconds. Press `OK ' to accept and select the minute. Press and release, or press and hold down the 'UP ' or `DOWN ' button to increase or decrease the minute setting by 1 minute similarly to the hour setting. Press `OK ' to accept and select the day of the week. Press and release the `UP ' or `DOWN ' button to change the day of the week to the following or previous day. Press and hold the `UP ' or `DOWN ' button for 2 seconds or longer to increase or decrease the day of the week by 1 day every 0. 5 seconds. The time and day of the week is now set. Note: Use the outer edge of buttons to toggle through functions. In the event that Thermostat remote is in operative ie Flat batteries or damaged unit can still be used but only on the one factory setting of high fire Medium fan. Unit will start as per normal 3 minutes on Low Fire and Fan, but them will go to High Fire, Medium Fan. This switch is only for use in the event of failure of Remote Thermostat. Page 8. Manual mode. The manual mode allows setting the temperature at any level. To select Manual mode, firstly the thermostat must be turned on, then press and release the `A/M' button until MANUAL appears on the display. The flame height and fan speed are not manually adjustable. The flame height and fan speed are set by the thermostat according to the difference between the set temperature and the current temperature. The flame height (Low or High Fire) or Fan Speeds are not manually adjustable. They are automatically controlled by the thermostat in the program cycle. This will vary according to the selected temperature and the actual room temperature. The display may show a Medium Fire symbol during operation however this function is not available with this heater and the heater will be operating on High Fire when Medium fire symbol is displayed. In the manual mode, adjust the set temperature by pressing or releasing the `UP' or `DOWN' buttons. Press and hold the `UP' or `DOWN' buttons to increase or decrease the temperature by 1°C every 0. 5 seconds. . [. . . ] Check that the batteries are in place correctly. Replace the batteries with new batteries and see if thermostat display appears. Check safety interlock mode The screen back light is not working. The back light will only appear when the thermostat is on. [. . . ]