User manual CANON CANOSCAN LIDE 90

[. . . ] The power is activated as soon as the computer is turned on. · When CanoScan LiDE 60 is connected to the USB 1. 1 port on Windows XP and "HI-SPEED USB Device Plugged into non-HI-SPEED USB Hub" message appears, ignore the message. The scanner operates in this condition without problems. 5. [. . . ] 2 Start ArcSoft PhotoStudio. Select [start], [(All)Programs], [ArcSoft PhotoStudio 5. 5] and [PhotoStudio 5. 5]. Macintosh Double-click [Applications] folder, [PhotoStudio] folder, and then [PhotoStudio] icon. ScanGear CS window 3 Click [File] menu, [Select Source] and select the scanner model. 4 Click the acquire icon or click [File] menu and select [Acquire]. 5 Select a Select Source option and click [Preview]. 7 Click the close box (Windows) or (Macintosh) in the ScanGear CS window, and save the scanned image in the PhotoStudio window. For more information about ScanGear CS, click (HTML format manual). button and refer to the Scanning Guide Bottom Top 6. Using the Scanner Buttons COPY Button Prints (copies) the scanned image with a printer. SCAN Button Forwards the scanned image to the image editing program, ArcSoft PhotoStudio. PDF Button (CanoScan LiDE 60 only) Saves the scanned image as a PDF file. E-MAIL Button Attaches the scanned image to a new e-mail message. 7. Setting the Stand (CanoScan LiDE 60 only) 1 Position the scanner directly above the stand on a slight angle. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. Use of shielded cable with the ferrite core provided with the scanner is required to comply with Class B limits Subpart B of Part 15 of the FCC rules. [. . . ] Use of shielded cable with the ferrite core provided with the scanner is required to comply with Class B limits Subpart B of Part 15 of the FCC rules. Do not make any changes or modifications to the equipment unless otherwise specified in the manual. If such changes or modifications should be made, you could be required to stop operation of the equipment. [. . . ]