User manual CANON EF 180MM F/3.5L MACRO USM BROCHURE

[. . . ] Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. Do not make any changes or modifications to the equipment unless otherwise specified in the manual. If such changes or modifications should be made, you could be required to stop operation of the equipment. RADIO INTERFERENCE REGULATIONS (For 120V models) This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Interference-causing equipment standard entitled "Digital Apparatus", ICES-003 of the Industry Canada. [. . . ] After you turn on the power, the Print key indicator on the keyboard lights red. After the unit is warmed up, this indicator lights green and the unit is ready to print. Set the film type (negative or positive), or select automatic detection. Press the Negative/Positive key on the keyboard or operation panel to make your selection. The lamp next to the key indicates the current setting. Negative Positive Auto Produce a positive print from negative film. Produce a positive print from positive film. The unit automatically detects the film type and produces a positive print. The Positive or Negative lamp flashes during printing to indicate the detected film type. or The HZ-05 zoom lens has no function to automatically switch between Negative and Positive. When using the HZ-05 zoom lens, always use the Negative/Positive switching key to select ( ) negative or ( ) positive. The unit may be unable to detect the film type if the black/white ratio on the film is almost even, or if you have selected a small area near the edge of the film for printing. At that time, the print number display returns to "01". 20 OPERATING PROCEDURES When you select the paper tray, the current paper size appears briefly on the print display. Make sure that the displayed size matches the paper size in the paper tray. A mismatch will produce an error when you try to print. If the sizes do not match, re-setting the paper size as follows. If using the paper tray, set the paper size of the paper tray. (1) Press the cassette select key and keep on for about 5 seconds to enter the paper size select mode, until the lamp of the paper ) starts blinking. At that time, the current paper size aptray ( pears on the print display. (2)Then, press the plus/minus key to set the correct paper size. The size indicator is displayed on the print display as follows. A4 Letter B5 Legal A3 Ledger B4 (3) Press the cassette select key to complete the setting. Set the number of prints that you want to make. [. . . ] (➞32) Pull out the lens holder and adjust the lens so that it is mounted correctly. (➞10) Re-load the tray with the correct paper size, or change the paper size of the paper tray. (➞20) If the printer is off, turn the printer power switch on. Solution Remove the jammed sheet from the printer. [. . . ]