User manual CANON ELURA 10

[. . . ] COPYRIGHT WARNING: Unauthorized recording of copyrighted materials may infringe on the rights of copyright owners and be contrary to copyright laws. digital Video Camcorder , ELURA and Compact Power Adapter , CA-600 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] Push the docking unit onto the camera and turn the locking screw clockwise to fix it securely onto the base. To remove, turn the locking screw counter-clockwise and pull the docking unit from the base of the camera. for greater creative control over audio recording , you can connect an external microphone to the camera via the DU-200 Docking Unit's MIC terminal. You can monitor the sound while recording by attaching stereo headphones to the H terminal on the docking unit. You can adjust the volume of attached headphones by turning the selector dial. The selector dial also controls the speaker volume once you remove the headphones from the headphone socket (p. The camera has an automatic wind screen to prevent wind noise from interfering with the sound track. (It does not operate with an external microphone). Make sure it's off when you want the microphone to be as sensitive as possible. Use the wind screen when recording in windy places such as the beach or near buildings. This is useful when you want to include yourself in the picture when recording. The camera starts to record after a 10-second countdown period (or after two seconds when you use the wireless controller). SELF-TIMER disappears from the display when recording begins. After recording a still picture for about six seconds, the camera automatically goes into record pause mode. notes: · Initially the tally lamp flashes once a second, then just before recording it starts flashing more quickly for a few seconds before the camera starts to record. If you have the beep turned on, it sounds each time the tally lamp flashes before recording. The camera automatically adjusts the focus and exposure two seconds before the countdown is complete. The green F mark is also displayed at this time. If you are using the wireless controller, the green F mark is displayed immediately after you press the start/stop button. When you are recording in situations where the lighting may change suddenly, you can lock the exposure at the current level in order to control the brightness of the image. Press it again to return to the automatically set exposure level. When the exposure is locked, you can adjust it manually, making the picture brighter or darker in order to deal with difficult lighting conditions, or to manipulate the mood of the scene. [. . . ] DV Camcorders covered by this limited warranty will be repaired and returned to you without charge by the CUSA Center or the Service Facility. Repairs not under warranty will be at such cost as the CUSA Center or Service Facility may from time to time generally establish. This limited warranty covers all defects encountered in normal use of the DV Camcorder, and does not apply in the following cases: (a) Loss of or damage to the DV Camcorder due to abuse, mishandling, improper packaging by you, alteration, accident, leaking batteries, exterior nicks, scratches or dents, electrical current fluctuations, failure to follow operating instructions, maintenance and environmental instructions prescribed in CUSA's instruction manual, or service performed by other than a CUSA Center or Service Facility. (b) Use of parts or supplies (other than those sold by CUSA) which cause damage to the DV Camcorder or cause abnormally frequent service calls or service problems. [. . . ]